While connecting to the console after system save, we’re unable to get to the login page

Tags:
AS/400
Data Center
DSP01
In our data center, we have run the system save manually through console using DSP01. But we're  unable to get the login prompt. In bottom line getting 9030 .. on DSP01 login page. What should we do?
0

Answer Wiki

Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

Discuss This Question: 4  Replies

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • ToddN2000
    Did you lose the console during save? was the system in a restricted state? Have you tried an IPL? I assume that DSP01 is your main system console. If any other PC's can login, check that the DSP01 is varied on, and the subsystem it's attached to is up and running.
    134,585 pointsBadges:
    report
  • Brijesh
    Looks like the system is in a restricted state. If so, then users can't access the system.
    14,450 pointsBadges:
    report
  • TamilselviK
    DSP01 status is signon display and DSP02 is varied on.
    30 pointsBadges:
    report
  • ToddN2000
    In your initial post yo say you don't have a sign on display for DSP01. You say the status is showing it is "sign on". You could try varying it off then varying it back on with the reset option *YES (need to F4 ).
    Let us know if that works.
    134,585 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: