Turnover form RECOVER Status Change/Reset

Tags:
IN-USE
recover
Softlanding
status
Turnover
We have a form in RECOVER status. We need to reset the flag in the Turnover form file. I've reset forms before via DBU, etc., but I forgot how to do it. Thanks in advance for the help.


Software/Hardware used:
iSeries
1

Answer Wiki

Thanks. We'll let you know when a new response is added.

If your form is in RECOVER status, it means the form did not apply on the system, check for the joblog, there must be an issue. We mostly get object locks. And once you are sure the problem is fixed, purge the form (Take PP across the form number on the production system), there are other parameters that need to given depending on your setup. After the form is purged, go back to the test system or the system from where you are sending the form, change the distributed status of the form to ‘N’ and now resend the form. Email me for more info.

Discuss This Question: 1  Reply

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • ToddN2000
    You can always check out the PDF.It list a lot of problem handling issues. Just scan for your issue.
    125,530 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: