-
how can I include 3 ip addresses in a single fast ethernet port of a cisco router if the switch connected to that port is a d-link switch? do i have to create subinterface on that fast ethernet port?
Last updated: -
Cisco 2811 Fast Ethernet and LAN configuration
i have cisco2811 router and i want to configure its 2 fast ethernet on my isp and PC or lan. can someone with a good heart to help me what command i will use on configuration level on both router and lan to have an internet connection.
Last updated: -
I inherited a network that has a Cisco 2811 router setup with the following: interface FastEthernet0/0 no ip address no ip route-cache cef no ip route-cache duplex full speed 100 ! interface FastEthernet0/0.18 description Data VLAN encapsulation dot1Q 18 native ip address 10.221.18.1 255.255.255.0...
Last updated: -
a straight-through cable to your fast ethernet interface of a router
what would happen when you use a straight-through cable to connect your computer to the fast ethernet interface of a router
Last updated: -
Need help with VLAN configuration
I have a router connected with Fast Ethernet to switch in VTP Server Mode (containing 2 VLANs) and then connected to a switch in transparent mode with three VLANs and after it a single switch in client mode. All these switches belong to the same domain and I have done interVLAN routing in it and...
Last updated: -
Cisco 2811 router with Ethernet access to MPLS
Can a Cisco 2811 router support a 40Mbps MPLS connection using Fast Ethernet access?
Last updated: