QIBM_QJO_CHG_JRNRCV

325 pts.
Tags:
AS 400
iSeries
I created an exit program for QIBM_QJO_CHG_JRNRCV exit point. My exit program simply sends message to a message queue when it runs. However when i try to do a CHGJRN on the command line to put in new journal receivers, it looks like the exit program does not run because I did not get the message in the message queue. However when I leave the exit program registered in WRKREGINF, after a few days, I did get the exit program message indicating that some other journals in the iSeries have changed the journal receiver. Is there a way to debug IBM i exit programs? I checked QHST logs and did not find anything that might be related to the exit program run. Are there system logs that i can look into for information about why the exit program did not run when I manually do CHGJRN.


Software/Hardware used:
IBM i v7r2
0

Answer Wiki

Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

Discuss This Question: 1  Reply

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • Jpjawili
    Additional information:

    This:
    http://ibmsystemsmag.com/ibmi/administrator/security/exit-programs--an-emerging-system-security-option/?page=2

    says that i need to restart the corresponding server job. Which server job is used by the QIBM_QJO_CHG_JRNRCV exit program? 
    325 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: