Propagating vlan’s over a eigrp?

Dialerstring
5 pts.
Tags:
Cisco
Cisco 7200
Cisco switches
EIGRP
HP ProCurve
HP switches
Switches
VLAN
Hello, I have 2 switches - one in building X and the other in building Y. The buildings are connected via fiber and eigrp is the protocol that's setup between them. The buildings are p2p connections between 7200's. I need the Vlans to be propagated from switch "y" to switch "x" over the L3 connection. If the the link between the buildings were l2 - I could use VTP.  :(   Thanks!! E

Software/Hardware used:
HP Procurve Switches, Cisco 7200 and eigrp
Asked: Last updated:
Related Questions

Answer Wiki

Thanks. We'll let you know when a new response is added.

If the switches are linked by L3, then “normal” VLAN’s won’t be propogated automatically. The switches at opposite ends of the link will work “independently”; although traffic can be routed from one side to the other.

In fact, it is tricky (but not impossible) to have the same subnets active on opposite ends of a L3 link. So you will have a different set of VLANS on the two switches…

Discuss This Question: 1  Reply

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • Palooka
    Is it possible to divide switch interfaces into sub interfaces? This is what you do when you need to carry VLAN data across P2P on Cisco routers.
    10 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: