How to edit source code using \’copy and move\’ in AS/400

20 pts.
Tags:
AS/400
RPT
Source code
How can I edit source code using 'copy and move' in AS/400?
0

Answer Wiki

Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

Discuss This Question: 2  Replies

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • azohawk

    Using the following codes on the line number of a line:

    C=Copy line

    M=Move line

    MM (at begining and ending lines)= Move block

    CC (at begining and ending lines)= Copy block

    Mx (where x is a number value) = Move x lines starting at the current line

    Cx = Copy x lines (note: place a space after the number or it may read the line number as part of the number in both move/copy

    B=place copy/move line(s) before the current line  (also Bx)

    A=place copy/move line(s) after the current line (also Ax)

    Also explore  X, XX, Xx (exclude-hides lines or usefull in searches) and O, OO (overlay-copy/move over blank spaces on current line. (block)

    4,055 pointsBadges:
    report
  • John275ms

    Thank you. That's exactly what I needed.
    s/John


    20 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: