Hi, I have configured a cisco 1841 to sync with a ntp server. after entering the ntp command, show ntp status says that it is not yet synchronized but on show clock details shows that it is already configured based on the ntp server. These are the result of show commands and the running config
RouterA#sh ntp stat
Clock is unsynchronized, stratum 16, no reference clock
nominal freq is 250.0000 Hz, actual freq is 250.0000 Hz, precision is 2**24
reference time is D377AE03.0032F423 (05:58:27.000 GMT Tue Jun 5 2012)
clock offset is 0.0000 msec, root delay is 0.00 msec
root dispersion is 0.00 msec, peer dispersion is 0.00 msec
loopfilter state is 'SPIK' (Spike), drift is 0.000000061 s/s
system poll interval is 64, last update was 15404 sec ago.
RouterA#sh clock det
.10:15:16.023 GMT Tue Jun 5 2012
Time source is NTP
RouterA#sh ntp assoc
address ref clock st when poll reach delay offset disp
~10.200.13.1 .LOCL. 1 49 64 377 0.000 1000.03 1000.0
* sys.peer, # selected, + candidate, - outlyer, x falseticker, ~ configured
RouterA#sh run | in ntp
ntp source FastEthernet0/0
ntp server 10.200.13.1
FastEthernet0/0 is our interface going to the ntp server.
Free Guide: Managing storage for virtual environments
Complete a brief survey to get a complimentary 70-page whitepaper featuring the best methods and solutions for your virtual environment, as well as hypervisor-specific management advice from TechTarget experts. Don’t miss out on this exclusive content!
No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.
Your password has been sent to:firstname.lastname@example.org
To follow this tag...
Thanks! We'll email you when relevant content is added and updated.
Share this item with your network: