Change Default on StrPrtWtr CMD within iSeries Nav.

5 pts.
Tags:
AS/400
iSeries
iSeries Navigator
How can I change the default on StrPrtWtr CMD within iSeries Navigator?


Software/Hardware used:
I5 Ver 7.1
1

Answer Wiki

Thanks. We'll let you know when a new response is added.

Prompt this command: CHGCMD CMD(STRPRTWTR)
To change Command defaults PROMPT CHGCMDDFT

Discuss This Question: 2  Replies

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • memallazzo
    We did that command on the "green screen" and it held the change. The issue is the cmd with INav is not holding the change.
    35 pointsBadges:
    report
  • ToddN2000
    Check to see if the command exists in more than one library. You may need to change more than one. I don't have access to iNavigator, how do you select the command, by mouse click or enter it on command line?
    136,530 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: