AS400 – Sysopr MSG ” CHG0064″

Syedm

180 pts.

Tags:

AS/400

IBM iSeries

QSYSOPR

V5R3

Message ID "CHG0064"

Message "Please mount the tape from Account Reconcilemnet Services" ( G C)

&n Recovery. . . . : Enter 'G' when ready or 'C' to cancel.

What it means and what steps should be taken?

Thanks.

Software/Hardware used:
AS400 V5 R3

Asked: May 19, 2011 6:20 AM Last updated: May 23, 2011 3:07 PM

Answer Wiki

Last updated: May 19, 2011 6:14 PM GMT

Teandy5,860 pts.
History
Contributors
- Ordered by most recent
- Teandy5,860 pts.

Thanks. We'll let you know when a new response is added.

This does not sound like any standard IBM error message I know of. Are you installing or upgrading a software pakage? If you are, then find the tape from the “<i>Account Reconcilemnet Services</i>”, put it in the tape drive, enter the letter g on the message line and then press enter.

A little more information about what you are doing may get you a better answer.

Discuss This Question: 4 Replies

HMSSL2K May 19, 2011 7:20 PM GMT

We do need more info to give you a better answer

3,175 pointsBadges:

report
TomLiotta May 19, 2011 11:57 PM GMT

The message ID CHG0064 and text that includes "Account Reconcilemnet Services" is almost certainly an application message. We have no way to know for sure what it means. It looks like it means someone should mount a tape in the tape drive, and then type 'G' in the message display and press <Enter>. Usually a 'G' tells programs to 'go' and 'C' tells programs to 'cancel'. You respond to the message with 'G' after you mount the tape in the drive because you want the program to start going again after a tape is ready. But we can only guess because we don't have the same programs that you have. Tom

125,585 pointsBadges:

report
Syedm May 20, 2011 5:53 AM GMT

Thanks everyone for the reply and suggestions I was not installing any application when this message appeared, bytheway I already passed this message to our development/software support team for further investigation

180 pointsBadges:

report
Splat May 23, 2011 3:07 PM GMT

If you receive the message again, use F9=Display message details to determine which job sending it.

12,270 pointsBadges:

report