Configuring Multiple SSIDs in Cisco 1250 Access Points Series 5
Posted by: Yasir Irfan
Multiple SSID, Configuring Multiple SSID in Cisco Access Point, Cisco Aironet 1250 Series Access Points, configuring multiple SSIDs, VLANS, Cisco Configurations, Wireless, Cisco Wireless, Cisco Access Points, Cisco Aironet 1250, Cisco Aironet 1250 Access Point, Sample Configurations, configuration scenarios, Windows 2003 Server, Wireless Clients, SSIDs, Native VLAN, Cisco Catalyst 3560 Switch, Cisco Catalyst 6500 Series Switch, IOS Version 12.4(10b) JDA3, IOS version 12.2(44) SE1, IOS version 12.2(18) SXF14, Cisco IOS, Running Configuration, show running-config, ping command, Ping
Dear all lets proceed further with the configuration of the Cisco Catalyst 3560 Switch
Configure the Cisco Catalyst 3560 Switch.
In this step we will configure the Cisco Catalyst 3560 Switch port which is connected to the Cisco Aironet 1250 Series Access Point to the wired network. We will configure the Cisco Catalyst 3560 Switch port, which is connected to the Cisco Aironet 1250 Series Access Point as trunk port because this port will carries traffic for all the VLANs on the wired network. In our case the VLANs are VLAN 101, 102 and the native VLAN 100.
When you configure the Cisco Catalyst 3560, which connects to the Cisco Aironet 1250 Series Access Point ,ensure that the native VLANs that you configure match the native VLAN on the Cisco Aironet 1250 Series Access Point. Otherwise, frames are dropped. In order to configure the trunk port on the Cisco Catalyst 3560 Switch, use the following commands from the CLI on the Cisco Catalyst 3560 switch:
Note: In our scenario the Cisco Aironet 1250 Series Access Point is connected to a Cisco Catalyst 3560 Switch to the port number Giga Ethernet 0/20
ITKE-Cisco(config)#interface interface gigabitEthernet 0/20
ITKE-Cisco(config-if)# switchport mode trunk
ITKE-Cisco(config-if)#switchport trunk encapsulation dot1q
ITKE-Cisco(config-if)#switchport trunk native vlan 100
ITKE-Cisco(config-if)#switchport trunk allowed vlan 101,102
ITKE-Cisco(config-if)#switchport nonegotiate
ITKE-Cisco(config-if)#
(The above commands configures the Giga Ethernet port 0/20 as trunk port, with a dot1q encapsulation , with VLAN 100 as a native trunk VLAN ).
Note: Cisco IOS Software-based Aironet wireless equipment does not support Dynamic Trunking Protocol (DTP). Therefore, the Cisco Catalyst 3560 must not try to negotiate DTP.
With this configuration we have successfully completed the configuration of multiple SSIDs in the Cisco Aironet 1250 Series Access Point . In the coming post I will post the snap shots for the connection established to SSIDS ADMIN and GUEST. Basically we will test the connectivity with the ping command.
0 Comments
RSS Feed
Email a friend
