Network technologies and trends » Intervlan routing

How to configure intervlan routing between Cisco Catalyst Switches and HP Procurve Switches Series 2

Yasir Irfan — Wed, 24 Sep 2008 08:27:05 +0000

In my previous post I did discussed about the how common terminologies are applied by both Cisco & HP, now it’s time proceed further , in this example we will create two VLANs and make intervlan communication between HP Procurve Switches and Cisco Catalyst Switches.

We will create 2 VLANS in both Switches, as shown in the below table

Now let’s see what configuration commands required to create a VLAN, and enable intervlan communication between HP Procurve Switches and Cisco Catalyst Switches.

How to configure intervlan routing between Cisco Catalyst Switches and HP Procurve Switches Series 1.

Yasir Irfan — Mon, 22 Sep 2008 06:53:07 +0000

In this series of article you are going to experience how to configure VLAN trunking between HP Procurve Switches and Cisco Catalyst Switches.

Before proceeding further lest understand the basic terminoly applied by both Cisco and HP for the following things

When it comes to VLANs in Cisco every one thinks of the term TRUKING.

HP applies trunking for ether channel where as in Cisco it applies for VLANs

Let’s compare how both vendors define Trunking

Source:HP

VLAN Terminologies applied by Both Cisco & HP

to be continued in next series