Home > IT Blogs > Network technologies and trends/

Network technologies and trends:

%DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics…

1
August 8, 2012  2:42 PM

What is the error “BUS_HDR_ERR: EARL L2 ASIC #0: Dbus Hdr. Error occurred. Ctrl1 0x930D0EBD” in Cisco 6500 Series Switch? – part 2



Posted by: Yasir Irfan
%CDP_PD-2-POWER_LOW: All radios disabled, %DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics..., %EARL_L2_ASIC-DFC9-4-DBUS_HDR_ERR: EARL L2 ASIC #0: Dbus Hdr. Error occurred. Ctrl1 0x930D0EBD

As mentioned in my previous post the error “BUS_HDR_ERR: EARL L2 ASIC #0: Dbus...

  Bookmark and Share     0 Comments     RSS Feed     Email a friend

May 25, 2011  5:17 AM

SUP 720 -3B Supervisor Engine Crashed



Posted by: Yasir Irfan
%DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics..., %Software-forced reload, bootflash:, Breakpoint exception, Cat6k-Sup720/SP processor, Cisco Catalyst 6500, Cisco Catalyst 6513 Switch, Cisco Systems, Cisco TAC Support, Cisco TAC team, Cisco Troubleshooting, Core Switch, CPU signal 23, faulty SUP, Networking, PC = 0x41D8BE6C, rommom mode, SUP 720- 3B failing to boot, SUP 720-3B is crashed, SUP 720-3B supervisor engine, Supervisor Engine failed, System Bootstrap, TAC Case, TAC Engineer, Version 8.1(3), Writing crashinfo to bootflash:crashinfo_20110523-131601

In my previous post I talked about the crashed Sup 720- 3B supervisor Engine for a Cisco Catalyst 6513 Switch. Since there was no ray of hope for the SUP 720-3B Supervisor Engine and I couldn't...

  Bookmark and Share     0 Comments     RSS Feed     Email a friend

May 24, 2011  5:14 AM

SUP 720- 3B failing to boot



Posted by: Yasir Irfan
%DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics..., %Software-forced reload, bootflash:, Breakpoint exception, Cisco Catalyst 6500, Cisco Catalyst 6513 Switch, Cisco Systems, Cisco TAC team, Cisco Troubleshooting, Core Switch, CPU signal 23, PC = 0x41D8BE6C, rommom mode, SUP 720- 3B failing to boot, SUP 720-3B is crashed, SUP 720-3B supervisor engine, Supervisor Engine failed, TAC Case, Writing crashinfo to bootflash:crashinfo_20110523-131601

Friends we have a Cisco Catalyst 6513 Switch installed with SUP 720-3B as a supervisor engine. From past 7 years its working fine but suddenly we the SUP 720-3B supervisor Engine failed. The SUP 720-3B is always going in to rommom mode and I am getting the following error

  Bookmark and Share     0 Comments     RSS Feed     Email a friend

1