Network technologies and trends:

bootflash:

1

July 31, 2011  12:52 PM

What is CMP in Nexus 7000 Series Supervisor Module?



Posted by: Yasir Irfan
active/standby mode, Auxiliary serial port, bootflash:, Cisco NX-OS device, CMP, Connectivity Management Processor, Console port, continuous operation, control processor, DRAM, dual core processor, front panel management Ethernet port, Intel Xeon processors, Nexus 7000 Series Switch, NVRAM, Over View of Nexus Supervisor Engine 1, RAM, Supervisor Engine 1, supervisor Engine Module, supervisor module, supervisor module console port, USB, What is CMP in Nexus 7000 Series Supervisor Module?

The Connectivity Management Processor (CMP) is separate processor on the Cisco Nexus 7000 Series supervisor module that is in addition to the main control processor (CP). The CMP provides a second network interface to the device for use even when the CP is not reachable. You can access the CMP to...

May 25, 2011  5:17 AM

SUP 720 -3B Supervisor Engine Crashed



Posted by: Yasir Irfan
%DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics..., %Software-forced reload, bootflash:, Breakpoint exception, Cat6k-Sup720/SP processor, Cisco Catalyst 6500, Cisco Catalyst 6513 Switch, Cisco Systems, Cisco TAC Support, Cisco TAC team, Cisco Troubleshooting, Core Switch, CPU signal 23, faulty SUP, Networking, PC = 0x41D8BE6C, rommom mode, SUP 720- 3B failing to boot, SUP 720-3B is crashed, SUP 720-3B supervisor engine, Supervisor Engine failed, System Bootstrap, TAC Case, TAC Engineer, Version 8.1(3), Writing crashinfo to bootflash:crashinfo_20110523-131601

In my previous post I talked about the crashed Sup 720- 3B supervisor Engine for a Cisco Catalyst 6513 Switch. Since there was no ray of hope for the SUP 720-3B Supervisor Engine and I couldn't...


May 24, 2011  5:14 AM

SUP 720- 3B failing to boot



Posted by: Yasir Irfan
%DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics..., %Software-forced reload, bootflash:, Breakpoint exception, Cisco Catalyst 6500, Cisco Catalyst 6513 Switch, Cisco Systems, Cisco TAC team, Cisco Troubleshooting, Core Switch, CPU signal 23, PC = 0x41D8BE6C, rommom mode, SUP 720- 3B failing to boot, SUP 720-3B is crashed, SUP 720-3B supervisor engine, Supervisor Engine failed, TAC Case, Writing crashinfo to bootflash:crashinfo_20110523-131601

Friends we have a Cisco Catalyst 6513 Switch installed with SUP 720-3B as a supervisor engine. From past 7 years its working fine but suddenly we the SUP 720-3B supervisor Engine failed. The SUP 720-3B is always going in to rommom mode and I am getting the following error   Bookmark and Share     0 Comments     RSS Feed     Email a friend


1

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to: