The command is <b>”ip helper-address 184.108.40.206″.</b>
After you log in, you’ll need to go into the “enable” mode by typing <i>”enable”</i> at the prompt.
You’ll then need to change into “Config mode” by typing <i>”conf t”</i>
Enter into the interface command context by typing in “<i>interface FastEthernet0/1</i>”* You’ll need to replace the <i>”FastEthernet0/1</i>” part with the right interface*
Finally, type in “<i>ip helper-address 220.127.116.11″</i>.