V7R1 with UPS and power failure

5 pts.
Tags:
Shutdown
UPS
V7R1
Is there a way in V7R1 to receive notification of a power failure across the network, eliminating the need for a serial cable connection?

Software/Hardware used:
iSeries, V7R1

Answer Wiki

Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

Discuss This Question: 1  Reply

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.
  • TomLiotta

    A power failure for what components? Obviously a power failure that affects networking will make it difficult to send any notification at all.

    How is your system set up to handle notifications of power outages? Have you created a *MSGQ to receive power messages and set the QUPSMSGQ system value to point to that *MSGQ? Do you have programming assigned to monitor that message queue? If so, your programming can send messages anywhere you want them to go.

    Tom

    125,585 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: