We use a dialup method to retrieve EDI from one of our TPs. Recently, the phone # that dials out from, was turned off, which it was obvious something was wrong, there were tons of error messages when the job that used the dial up kicked off. Since then, the phone line has been turned back on, but I am still getting an error, when the job kicks off. The error is "switched connection failed for device AUTO596". When I view the job in the Q, the configuration status of LIN012 says CONNECT PENDING - and it remains at that status until the job timeouts and ends. Any ideas?
November 26, 2007 2:09 PM