Too high % temp. addr. in WRKSYSSTS – AS/400 aka iSeries
In WRKSYSSTS the temp. addr. is too high and not getting lower after IPL.
% perm addresses . . . . : 0,128
% temp addresses . . . . : 10,453
Can anybody tell me how to get this % lower?
thnx Rita
Software/Hardware used:
Software/Hardware used:
ASKED:
June 9, 2005 6:56 AM
UPDATED:
October 26, 2009 4:46 AM
Answer Wiki:
Hi,
Have you looked at your job table limits? Use the command dspjobtbl.
Also look at your QACTJOB and QADLACTJ system values.
Hope that helps.
Juliet
=================================================
Why do you have the idea that they're too high? I wouldn't be concerned until the percentages hit maybe the 90% mark, and then I'd only be concerned if they were rising at a rate that seemed would pass 100% before I planned the next i5/OS upgrade. I've never seen an AS/400 system get as high as 90%, though I've heard that some large high-volume CISC systems did years ago. I haven't heard of it since RISC systems have settled in.
Tom
To see all answers submitted to the Answer Wiki: View Answer History.
Hi,
Have you looked at your job table limits? Use the command dspjobtbl.
Also look at your QACTJOB and QADLACTJ system values.
Hope that helps.
Juliet