While running a backup job on the AS400, the job was ended. Now the status of TAP01 is FAILED. Apparently, the device is still active? Any ideas?
When I try to vary it off, I get this:
Device TAP01 not varied off. Error occurred.
Message ID . . . . . . : CPD2643 Severity . . . . . . . : 40 Message type . . . . . : Diagnostic Date sent . . . . . . : 09/26/13 Time sent . . . . . . : 10:48:07 Message . . . . : Device TAP01 not varied off. Error occurred. Cause . . . . . : Device TAP01 was not varied off for one of the following reasons:
--The device is active.
--The job default wait time was not long enough to allow the vary off function to complete.
Recovery . . . : Do one of the following: --Try the request again when the device is not active. --Use the default maximum wait time (DFTWAIT parameter) in the Change Job (CHGJOB) command to increase the job default wait time. Then try the Vary Configuration (VRYCFG) command again.
Free Guide: Managing storage for virtual environments
Complete a brief survey to get a complimentary 70-page whitepaper featuring the best methods and solutions for your virtual environment, as well as hypervisor-specific management advice from TechTarget experts. Don’t miss out on this exclusive content!