VoIP

Cannot ping default gateway of ISP

Can Anyone help me that why i can not ping default gateway address 96.52.160.1 I am kind of frustrate that it looks everything OK to me but since last one week day and night i am trying to figure out that why it can not ping ISP and neither can open webpage (DNS are entered correctly) ...

Voice mail zero out configuration on Cisco IP Phone

how to configure nortel phone number as voice mail zero out on cisco ip phone number

Circuit Cards

Which circuit cards require 2 card slots in a CS1000

Avaya programing

How do I make a phone not ring and disturb a person at their desk when all of the phones ring with incoming calls?

Change Nortel S8000 from Three-phase to Single-phase power

We have just purchased 50 nortel gsm s8000 frames from europe. these frame are set up to use three phase power. We need them to be single phase power. is it possible to make this change and if so how. Or where would I find this information? The 3 phase power unit is part number NTQA90CD The...

Is there a way to convert a Nortel GSM S8000 frame from Europe, from 3 phase power to single phase power.

Is there a way to convert a Nortel GSM S8000 frame from Europe, from 3 phase power to single phase power. I was hoping that there would be a simple solution via a Nortel CAP or Procedure. user submitted question

Cisco 2811 - Divide Bandwidth

We have Cisco 2811 router with on serial interface and two fast ethernets. We planned to take 1 mbps leased line and we have to divide it into two parts. For one network is should be 300 kbps and the rest bandwidth for another network. Can any help in this.

Getting error 57 & 58 when user trying to login?

when ever user trying to login it is saying request timed out. Understood That when ever genesys is sending request to Avaya it is getting timed out. We have Avaya CM 2.0 and integrated with GVP.

"Critical Error 3,0 - Unable to start the core engine, the application can not continue"

Hello I have ran into an error message to which I cannot find an answer for.I am trying to run my Poivy and I keep getting this error message: "Critical Error 3,0 - Unable to start the core engine, the application can not continue" I have been using this program for 3 years and have never had a...

How to reset password on Norstar Modular ICS?

HOW DO RESET LOST PASSWORD ON NORSTAR MODULAR ICS

VOIP

I read your article about VOIP. Do you it has improved based on your last article about its disadvantages? Our company is looking for ways to save money on our phone bill. Any recommendation?

Cisco IP phone issue

We are on the CUCM 6.1 - I have a phone where the vm light and prompt is not working. I don't believe it's the phone because I rebuilt a new phone and am getting the same issue. The other phones at her office do have this issue and each one is setup the same. Is there something outside of the...

Switchvox AA350

I have a switchvox AA350 SMB server in my organization which I run. Recently I aquired analog lines for external calls. I put two of the lines into the switchvox (the server came with a four port anolg card)I configured the lines and I was able to make calls through my SIP phones.Yesterday I came...

Putting another extension on a 3904

I am trying to put another users extension onto an existing users phone. The problem I am running into is that the extension now rings on both phones. I do i get it to just show up without ringing?

ring back

Is there any way to make a 2500 phone ring back to itself for testing purposes? At the present time we need two people to do this testing. I was told that there was a code you could dial and then hang up and the phone would ring back to itself. Any ideas? Nortel CS1000 5.5 system

backbone capcity limitations on pandemic telecommuting

A few years ago in the great Avian bird flu scare, it was stated that in the US, there was only 10% spare capacity in the telecom/internet infrastructure to handle telecommuters. Does anyone have any better analysis of this potential choke point?

How can I solve Unrecognized object: GTHEME at 1628

i still got this message in ARCview, after o paste the file from desktop garp in the ARCview folder. this is to help to create custom datasets according to the user's manual.

CONFLIST for Meet-Me

I have Cisco CM 7.1. Meet-Me bridge and ad-hoc conferences work fine. CONFLIST softkey works properly in ad-hoc, but does nothing in Meet-Me. What parameter(s) should I check ?

Time-division multiplexing (TDM), synchronous vs. asynchronous

What is synchronous Time-division multiplexing? And why is it different from asynchronous?

Primary Rate Interface (PRI) from an Internet Service Provider (ISP)

We would like to use a Primary Rate Interface (PRI) for our video conferences however our current service provider states that they cannot provide the 64kbps speed per channel for video. Is this common or should any provider be able to provide the 64kbps functionality?