• How to set QoS for users connected to ever-changing switch ports

    We have a large enterprise network based primarily on Alcatel-Lucent switches that support QoS, and we are implementing video-conferencing based on Polycom equipment. Setting QoS on switch ports for Polycom appliances is not much of a problem, but we are about to roll out video conferencing...

    NetworkingATE1,545 pointsBadges:
  • Propagating vlan’s over a eigrp?

    Hello, I have 2 switches - one in building X and the other in building Y. The buildings are connected via fiber and eigrp is the protocol that's setup between them. The buildings are p2p connections between 7200's. I need the Vlans to be propagated from switch "y" to switch "x" over the L3...

    Dialerstring5 pointsBadges:
  • Management software for HP 4000m switches

    Does management software exist for HP 4000M switches? What can be controlled or viewed through it? Where can I find it?

    NewnanIT1,110 pointsBadges:
  • Preventing issues with PC/Mac integration

    We are adding 10 new mac’s to our PC network we are adding a gigabit module to our 4000m switch. What else should we do to prevent issues with the pc/mac integration?

    NewnanIT1,110 pointsBadges:
  • How do network hardware devices support IPv6?

    I read that most routers and switches support IPv6, but how they support the protocol differs. The article said that specific network hardware devices have dedicated network processors while others have general purpose processors, which are worse because those forward packets at a slower rate. How...

    SearchEnterpriseWAN1,040 pointsBadges:
  • Layer 3 switch or router ?

    I am looking at having multiple networks created at the same premise. Each one will run a zone with work stations and servers. I am a bit confused between multiple routers and a layer 3 switch ? What do you guys suggest ?

    Aromalrajagopal55 pointsBadges:
  • Suggestions for replacing HP Procurve 4000m switches

    We are replacing our hp procurve 4000m switches for some new technology. What would you recommend for a modern day version of these 4000Ms? They lasted 10+ years.

    ITKE344,785 pointsBadges:
  • How to connect four FC brocade switches ?

    Hi, i have Four FC brocade switches two internal in HP Blade server connected direct with blade servers and two FC brocade switches (DS-300B) connected direct to EMC SAN storage (CX4-120) , so my question now how i can connect four switches to be able to see all blade server HBA (WWN) throuh two...

    Karimfalcon10 pointsBadges:
  • Connect console of 3com switch to PC Laptop through port 25 Up

    Dear All, I have to connect console of 3com switch to a PC. Kindly Help Regards

    SwitchesRouters5 pointsBadges:
  • Can’t Connect using 24 port Baylan Switch while working okay with an old baylan 08 port switch

    Can't Connect using 24 port Baylan Switch while working okay with an old baylan 08 port switch that has an Uplink additional port. When i connect using 24 port switch, it starrts dropping packets and ping response breaks continously. Can any one help on this. Please! My network structure is =>...

    Kimbukhari5 pointsBadges:
  • Configuring managed switch and router in order to have Internet…

    Dear Sir, Could you please help me concerning the following matter: I have Cisco Catalyst 2950 managed switch connected to Linksys WRT54G - Wireless-G Broadband Router, which is then connected to ADSL modem. I need the following scenario: -two VLANs configured on the managed switch, so there will...

    Ivoivo0 pointsBadges:
  • APC UPS for supporting multiple machines

    We have an APC UPS that can shut down a server using USB or serial. Can we do this over ethernet to a switch? We want one device to support multiple machines.

    TeachMeIT975 pointsBadges:
  • SUBNETTING

    Hi What is the broadcast address for the IP subnet 192.168.100.32 given a subnet mask of 255.255.255.224. I want to know step by step procedure on how to get the right ans. Brgds Mark

    Markmu5 pointsBadges:
  • Preference of fiber channel over ethernet in FC switch?

    To put it mildly, my experience with fiber channel switches is limited.  In actuality my only real experience is from a couple dozen google searches in trying to find the answer to these questions. Anyway, here's a bit of background on what's going on before I get to the questions:  My company...

    Tratch5 pointsBadges:
  • Optimize Multicast with deployement ghost image (2960 connected 3750)

    Hi, How methode to Optimize Multicast with deployement ghost image (2960 connected 3750). Because, since i have switch cisco the bandwith decrease for image deploy. The bandwith very slow ?. The igmp snooiping has activate. Best regards.

    Hben35 pointsBadges:
  • VOIP and Routing Question

    Please advise. We have a branch office with a Cisco 3560 48/port POE switch. The branch office has 20 users in VLAN 1. The switch interfaces with a Cisco 2811 router. The router has a T1 point to point to our main office. We are putting in VOIP so each user has a phone -> PC. How would I...

    Dprattmcse5 pointsBadges:
  • Anyone know of a free simulator for Cisco router and switch configuration?

    Can anyone recommend or suggest a free simulator for Cisco router and switch configuration? Thank you!

    NetworkingATE1,545 pointsBadges:
  • What brand of routers/switches do you trust the most?

    We're wondering what everyone is using for a brand of wireless routers and switches? What do you prefer to use in the enterprise versus at home or in personal networks? What are your suggestions for SMBs to large corporations? We've got 150 knowledge points for our favorite answer!

    MelanieYarbrough6,345 pointsBadges:
  • How to define local bandwidth and international bandwidth on Cisco 3845 with 2960 switch

    I have a 1gb local bandwidth with 10mb international bandwidth in my data center. and my problem is i don't know how to share the international bandwidth equally to my clients. I don't know if there are device i need to use or is there are anyways i could just control the international bandwidth....

    Bosslui5 pointsBadges:
  • User(s) are complaining of delays when using the network. What would you do?

    Q: User(s) are complaining of delays when using the network. What would you do?

    Sappidi5 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following