• I have a weird ping issue on 3com router, any ideas?

    When I ping our main frame relay router, a Netbuilder 227C running SW/NBRO-CF,9.1 firmware. It gets its LAN feed from a Nortel 8100 switch. This problem propagates across the frame relay circuit to the far end router (another 227C running 9.3 firmware) and Nortel 450 switch connected to it. See...

    Networkmanjohn10 pointsBadges:
  • Setting up RPC over HTTP

    We run a 2003 server with exchange 2003 ( one PC ). We have a leased line. Our router has an external IP which is nated to our servers internal IP. When we setup the remote outlook 2003 it won't connect to the exchange. We can load the SSL certificate and view the website in the "Default Web site "...

    Easybrian50 pointsBadges:
  • Need help designing a network for videoconferencing for a campus?

    What type of severs, routers, bridges, switches and cables are suitable for videoconferencing? Also, how do you design a network for videoconferencing for a campus? Please help me. Thank you.

    Networking Channel ATE30 pointsBadges:
  • Is it any good to have 1 QoS router on WAN with VOIP

    I am thinking of implementing VOIP on a network that links 2 sites via DSL and Linksys BEFVP41 routers which do not support QoS. I am wondering whether it would make any sense changing one of these routers with a RVS4000 to ensure good voice quality. I would like to avoid purchasing 2 new routers...

    EB35 pointsBadges:
  • Need help with load balancer configuration change on Cisco 11506

    I've got a mind boggling question about Cisco Loadbalancer 11506 series. Here is a sample config; ----------------------------------------- service WPST01 ip address 192.168.120.61 keepalive type HTTP string WPST01 active service WPST02 ip address 192.168.120.63 keepalive type HTTP string WPST02...

    NetworkingATE1,545 pointsBadges:
  • Need help upgrading Cisco 7507 router

    I'd want to upgrade IOS Router 7507 but min flash IOS new version requires 32 M. Cisco RSP8 (R7000) processor with 262144K/8216K bytes of memory. 46976K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes). 16384K bytes of Flash internal SIMM (Sector size 256K). How can router upgrade IOS?...

    NetworkingATE1,545 pointsBadges:
  • Page not found, but works if I change my IP address, it’s the only site I can’t access

    This is an odd situation. I have a Netgear router/firewall, internal address:192.168.0.150 All the PC's on the network have 192.168.0.xxx as address. Every web site I go to comes up except one. It's consistent across all PC's. If I change the IP address to anything other than a 192.168.0.xxx, I can...

    Questfar5 pointsBadges:
  • Cisco T1 configuration

    Currently have three cisco 2600s connected via T1s to a 3600 at the main branch. Right now the T1s are connected to TSU 100 (one 120) units, then into a serial WIC (1T) in the routers. We have T1 DSU/CSU cards to replace the serial wics. What would be the best configuration for the new WICs? (we...

    Nevyn35730 pointsBadges:
  • Project management, network design for public hotspot

    I want to provide a public hot spot at my restaurant but I need to protect the computers that are on the wired LAN created by the WAP router. I need to protect the wired devices from unauthorized access but still provide authorized access for PC-Anywhere and video surveillance cameras. How can I do...

    NetworkingATE1,545 pointsBadges:
  • How should I upgrade my network infrastructure?

    I am now upgrading the network infrastructure of my office and I have 10-15 computers. Now what I want to do is to connect to the Internet with a wireless or wired Ethernet connection and connect the Microsoft workgroup sharing with another wired Ethernet. Is it possible to connect a LAN connection...

    NetworkingATE1,545 pointsBadges:
  • Is it possible to install a network splitter below a router?

    will this create a ip conflict? how should i set it up?

    Urmomiscute5 pointsBadges:
  • commands

    2?'s You entered a command and need to remove it. What command do you use? In this case, you entered network 11.0.0.0 in the RIP routing process for AUS. #2 What is one of the two commands you can use to view the documentation of the description command?

    Vet11c35 pointsBadges:
  • Preventing a User from Accessing Confidential Files

    I have a home network which is hooked up to a Cox DSL Router. The Cox DSL Router is then plugged into a Linksys Wireless Router by CAT5. Running off of the Linksys Router is a CAT5 going into 1 desktop in the same room. I also have a desktop (main computer) that connects via Belkin Wireless. Now,...

    MattG085 pointsBadges:
  • Network setup

    Our organization has been using a small office network and would like to expand it to cater for the increasing organization needs. We have therefore upgraded our Internet connection to a DSL with 15 IP addresses and purchased high end servers to manage a network of an estimated 150 computers. I was...

    Wanaug5 pointsBadges:
  • how to configure leasedline configuration to my network which is having more than 300 pc’s thru NAT server on router

    how to configure leasedline configuration to my network which is having more than 300 pc's thru NAT server on router

    Kanal5 pointsBadges:
  • how can I share my files …

    hii guys i have 3com wireless, dsl modem and router actually i know how to share files but its to slow so i guess i have to configure some thing but i dont know how to do it so please can some one help me ??

    Haneya55 pointsBadges:
  • how to configure your cisco router to dial remote server has isdn modem

    hi : i have 2811 cisco router with bri interface , and i want to know away to make this router call remote server has isdn modem , but all the ways didnot works , can any one help me with that and i;ll be thankfull plz

    Pcangel10 pointsBadges:
  • Is it the encryption level?

    I've got a Linksys BEFSR81 wired router, which is networked to about 5 other Linksys/Motorola routers. The BEFSR81 is on WEP, as are the others. The system runs at a crawl after i download the first 5mb of most files. I have been told that it could be that it's because this system is on WEP. Is it...

    Strtme5 pointsBadges:
  • How a router helps in delivering and connecting two networks at different places

    How does a router help in delivering and connecting two networks at different places, say for example one sends some data from India to a friend in the USA and they are working on different machines: one is working on a PC machine and the other on a MAC machine?

    NetworkingATE1,545 pointsBadges:
  • Fixing a corrupted file

    I have a 2801 router, but the Nvram file is corrupted. When we try to copy the Running config is not working. The command I use is the following: copy running-config startup-config The error says it cannot save it. I don't know what's wrong. What should I do? Do I need to download the new IOS in...

    NetworkingATE1,545 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following