Hi, Is AT command valid for windows 2003 batch files? Is there any delimitor to be used after each statement in batch files?(when run on Windows 2003 platform) Best regards
Recently implemented change to group policy recommended by software vendor by the below instructions: 1. Click Start, point to Programs, point to Administrative Tools, and then click Domain Controller Security Policy. 2. Click Security Settings. 3. Click Local Policies, and then click User Rights...
i have a sbs 2003 on my network and i configure him to get all the fax of my company, the only problem is that when i configure him to route all the incoming fax to some mail it does not seem to work, i check the event log and i get error 32083 and with this massage: Unable to route fax...
From last few days I am facing this problem. When I shut down my Win 2000 Server(SP4) at the end of the day the end program-exlorer.exe dialog box comes up twice and it shuts down only after I click on the 2 end now buttons. Both end program dialog boxes are same and comes one after another. The...
hello! i'm working with a gateway 9510 server that has fans that run very loud at times than quiets back down again back and forth. i have updated the server through the gateway website downloads and the problem is still there. any suggestions for the next step? thanks! -thecheyguy
Hi all I have a three servers with windows 2000 (service pack4 ) and its running active directory and DNS also. My global catalog server (PDC) am calling as server ?A? , others are server ?B? and server ?C?. These are two servers are acting as BDCs. One of the BDC?s Hard disk was crashed last...
Hi There, I have installed (tried to) SP2 for Exchange 2003 on a Windows 2003 Srv Std Ed. The install failed first because I had Intelligent Message Filter v1 installed. So I uninstalled it and rerun the SP2 setup program. It failed again on the "Microsoft Exchange Messaging and collaboration...
Long story short, I discovered the NTFS permissions on all our Native Windows 2000 servers, at the root of each partition, had been reset to "Everyone." Of course I had my shares set to not propagate permissions, so that wasn't an issue. For some reason this did not affect the one box that we had...
Hey, We have 2 domains. Let's say domain 1 and 2. Both NT4 (yes, i know). Domain 1 has a range of 160.1 subnet 255.255.0.0, domain 2 162.1. . I'm situated in domain 1 and i want to make a BDC for domain 2. In the NT-server setup i can give IP or DHCP, DNS , WINS, .... Normally on our PC's we use...
Can any one give some usefull and urgent tips about database design example where i get for designing BPO company work flow parts...
Hello, How can I get sample Windows admin scripts? Do anybody know the sources / url's...?
Hi there.. I want to know if there is any way that i make my laptop standby and still i can access it via remote desktop over network, i.e. my laptop doesnt lose its IP address or close its network interfaces in standby mode. Is there any wake-up call for standby laptop over network to achieve this...
Hi all, I have some internet users who listen to online radio stations. I have asked them not to do it, as I feel like it probably uses up a fair amount of bandwidth. Is this correct, or does it use very little? Also, other than purchasing and installing software, is there a way to block music?...
Hi all, I have some internet users who listen to online radio stations. I have asked them not to do it, as I feel like it probably uses up a fair amount of bandwidth. Is this correct, or does is use very little? Also, other than purchasing and installing software, is there a way to block music?...
We recently migrated from Exchange 5.5 to Exchange 2003 and also moved from NT to Active Directory 2003. One of the main reasons we moved was to implement the compliance features of Exchange 2003 and Journaling. We need to keep all our emails in a central holding area for possible SEC audits. ...
Hi, I am trying to put port security on a port, I want it to shutdown if another computer gets plugged into that port. I followed the following steps: I set these options: switchport mode access switchport port-security switchport port-security maximum 1 switchport port-security violation...
Hi, My file server is WinNT 4.0. In my network I have Windows 98, 2000, Xp as clients. My problem is, I have one folder named 'Project' on my file server. Team Members(TM) have only update access rights, Team leaders(TL) have 'Change' rights. When TM is accessing and updating from Windows 2000 or...
I created a small office network between five computers (a WLAN actually), four of which I installed from scratch. The fifth, which I didn't install the OS (Windows XP) myself, can be seen in the workgroup under Microsoft Windows Networks form other computer, but an attempt to access it fails, with...
Hello, I would like to know the option(Compressing Old Files) which comes up during disk cleanup in win XP and win 2000. Is it good or bad? I mean, If I do the compression regularly will that effect my system/files in a long run? Is it same to that option (compress drive to save space) in disk...
I am running Windows XP (HE)(SP2) on an HP, Pentium IV PC. All installed programs and the operating system perform well... That includes Panda Platinum IS 2006 which has maintained a virus and spyware free environment. After performing a Windows XP Disk Cleanup and defragmentation sequence, the...


