Networking Services Questions and Answers

Recent IT Questions

121 - 140 of 259

WIRELESS BRIDGES

Dear Sir's, I have two wireless bridges. Master and Slave which are 800 ft apart and two high gain antennas are attached to these units. I am finding a disconnection problem with these bridges. It works for a while but gets disconnected and after doing powercycle on the slave end the...

View Answer   |  Dec 26 2005  9:06 PM GMT
Tech support, Hardware, Networking
asked by breathe

  0 pts.

Loadsharing between two ISPs

dear sir, I am looking for a load sharing solution between 2 leased lines for 2 different ISPs the diagram goes lke this: LAN-->Cisco Pix-->Router-->2 leased lines. can load-sharing be done at the router without extra configuration at the providers side? can CEF (cisco express forwarding)...

View Answer   |  Dec 26 2005  10:15 AM GMT
Hardware, Networking, Ethernet
asked by skullyMJ

  0 pts.

Windows Server 2003 Terminal services

I am configuring a server to be used as a file server for a small office. The server will be housed off-site and will need to be accessed remotely by 3 users. Is terminal services the best remote access solution in this case? If so can the server also handle licensing or is that necessary? I am new...

View Answer   |  Dec 19 2005  9:37 PM GMT
Networking, Networking services, DNS
asked by Stuntz

  0 pts.

How To Make A LAN In My House HELP!!!

currently i have 2 computers and i am using ADSL can anyone teach me hw to make a LAN in my house pls tell me fully THANKS THANKS THANKS

View Answer   |  Dec 18 2005  12:38 AM GMT
Networking, Networking services, DNS
asked by ITNoob

  0 pts.

Remote Syslog with MySQL and PHP

Dear All, i want to set up a Remote Syslog with MySQL and PHP on system with whitebox linux,can some tell me a step by step on how to install and configure this,also the requirement needed to complete the task Regards Edwin

View Answer   |  Dec 15 2005  4:43 AM GMT
Hardware, Networking, Network management software
asked by eduado

  0 pts.

LAN connectivity problem

I have a Compaq EVO n1020v notebook. This works fine in our office LAN and soemtimes it does not at all. Office LAN is a workgroup with ICS enabled in win 2K server. If I check the IP of the notebook it shows the IP of the LAN but never connects to the internet, can't access LAN...

View Answer   |  Dec 6 2005  1:35 AM GMT
Tech support, Hardware, Networking
asked by BinooDas1234

  10 pts.

dns problems

I have a DC with Exchange 2003 on Server 2003. I am having some DNS problems which I belive is causing Outlook to Exchange connectivity issues. I understand that there should be a DNS entry _ldap._tcp.dc._mcdcs in the DNS. I did not have this and I tried to manually add it. I have it in the...

View Answer   |  Dec 1 2005  3:57 PM GMT
Networking services, DNS, Active Directory
asked by amcdowell

  0 pts.

Transferring a Domain

Hi All, I have a server running on WindowsNT 4.0, we are upgrading to server 2003 on new machine and removing the old machine entirely from network, Could any body tell is there any way of transferring the exisiting users and policies/ entire domain setting to new machine as it is, and not making...

View Answer   |  Nov 30 2005  9:21 AM GMT
Networking, Ethernet, Networking services
asked by inamhaque

  15 pts.

Remore RS232 Control

Good Day All I wondered if anyone knows how to remotely access and control RS23 devices. I will give you my example. I have a PC which is attached to 2 RS232 devices. I would like to have some form of control of the devices attached to the PC from a remote location, like a PC in another room or...

View Answer   |  Nov 30 2005  6:25 AM GMT
Tech support, Hardware, Networking
asked by jondean

  0 pts.

bootp and virtual hostnames

I'm receiving a bootp request from a client machine on my bootp server. My server is not responding, and I think the problem is the that request is being sent to the hostname of the virtual IP (hostname_vip found in /etc/hostname.ce1:1 file). I see the name for the destination in the request...

View Answer   |  Nov 29 2005  9:39 AM GMT
Networking, Networking services, DNS
asked by gabercrombie

  0 pts.

Unable to remote connect to a server using server name.

I have a virtual server that have a different IP address than the host server. I was not successful when trying to connect to the VS using the its computer name. However, I can connect successfully using the IP address of the computer. What are the steps for troubleshooting and fix the problem? ...

View Answer   |  Nov 21 2005  1:32 AM GMT
Tech support, Networking services, DNS
asked by DavidBui

  0 pts.

AOL Spammer IP Identification

Concerning the ever increasing amount of received spam, to battle this I have a program with which I can extract the IP address from the sender for reporting purposes, however, I have been receiving an increasing amount from AOL proxy server for which I cannot aquire the senders IP address. Is...

View Answer   |  Nov 19 2005  11:56 AM GMT
Tech support, Disaster Recovery, Hardware
asked by Eyecatcher55

  0 pts.

Stop bit problem: USB to Serial Converter attached to motion controller, unable to set for 7-E-2

I have three different USB to Serial converters, one of them an isolated converter from B&B. One brand of motion controller I work on uses EVEN parity / 7 data bits / 2 stop bits as its default. I find that none of my converters will work on the controller in this configuration. If I borrow a...

View Answer   |  Nov 18 2005  5:36 PM GMT
Tech support, Administration, Hardware
asked by kfink04

  0 pts.

Upgrade step from win nt and win 2000 to win 2003

I have windowsNT and window 2000 servers with active directory which i want to upgrade to windows 2003,all servers meet requirement for new vesion.Now can same help me on how to upgrade?what steps should i take

View Answer   |  Nov 14 2005  2:16 AM GMT
Hardware, Networking, Ethernet
asked by eduado

  0 pts.

Implementing an Exchange server in VB6.

I am done with emplementing a LAN exchange server in VB6, now i would like to consider making it work world wide.. Can anyone please advise with the defrences between a LAN and a server that work World wide in a programmers point of view, and how can i implement that using VB 6? many thanks for...

View Answer   |  Nov 1 2005  10:28 AM GMT
Networking services, DNS, Network protocols
asked by sswar111

  0 pts.

"Controled" proxy

Hi, I need to control my user's access to different sites. for example user1 should be able to access www.yahoo.com on providing username/password, where user2 should be denied (or get password from Admin... :-) ), in otherwords the software can keep the profiles of different user to access my...

asked by Manije

  0 pts.

RDP connection is not the correct computer

Thanks in advance for any help! Im in a mixed 20002003 domain. When I RDP by name into several machines (all XP machines) in my building it is not the PC that I think it is. I check the actual PC name and its not the one I used to RDP into it, therefore not the machine I wantthink im looking at....

View Answer   |  Oct 21 2005  12:30 AM GMT
Tech support, Networking, Networking services
asked by kellarm

  0 pts.

simple remote administration

hey y'all... is there a way to do the following remotely? change passwords create a share on a server hard drive I have the adminpak installed on my workstation which allows me to do it. I want to be able to do it from ANY computer on the network. I have Win2k3 servers only, and WinXP clients...

View Answer   |  Oct 21 2005  10:41 AM GMT
Help Desk, Hardware, Networking
asked by TheVyrys

  0 pts.

DNS Old NT network

I have an old NT network with a DNS server on a W2Kserver. The DNS server was never installed correctly and I do not know that much about it. Also, it is in very bad shape and I am afraid to do too much to it. I have two locations connect over Frame relay. One location has the NT domain...

View Answer   |  Oct 18 2005  6:02 PM GMT
Networking, Networking services, DNS
asked by jtennyson

  0 pts.

PDC

Hi, My event viewer keeps throwing me the event id 16650 source SAM. I have read up on the net about the possibilities of the error but am but am confused. I have two servers which i will call server01 n server02. server01 is suppose to be the domain controller(though it seems as though its...

View Answer   |  Oct 12 2005  7:49 AM GMT
Networking services, DNS, Active Directory
asked by PRINCESS8

  5 pts.

121 - 140 of 259