CanĀ someone help me plz. At my job at a hotel we need to install this equipment. It is to be used as a backup for our servers already in place. My question is that I know nothing about these and as I read up on them I am confused about them. To me them [...]
I have a cisco 2811 router with two separate HWIC-1FE, i have two ISP links getting into the router and i would like help on configuration on how to balance the links such that if one goes down the other one picks traffic immediately.
If our domain controller goes down on our Windows Server 2003 Active Directory network what needs to be done to have the backup domain controller kick into action? Can we have them doing load balancing in a perfect scenario?
Hello. It is possible to load balance 2 isp (2 adsl link) with cisco 3560 L3 switch? how can I do it? thanks in advance! best regards.
Hi All, I am planning to install a Barracuda network load balancer for application load balancing and needs assistance or guidlines pdf for its installation. Here is my network setup. 1. 2 IBM blade servers installed with IBM netcool NMS application 2. 200 concurrent users will access the application from another network. 3. Plan to [...]
Do you have a download limit per user implemented in your environment to prevent excessive network load? How much of a limit do you have imposed? If you don’t, how did you justify the decision?
We have to location A & B, between location we have two 2 mbps ethernet converted leased line, now we are going to update one line to 4 mbps also want to configure Loadbalancing & automatic failover in case of any line fails. Please suggest better solution & cisco router to achive this.
What is NLB and it should be configured? Please tell me from the basic. It will be helpful for me. Thanks Boney
Is it possible to aggregate and then load balance the unequal ethernet circuits like so: I have two ethenet circuits on my Cisco router. Both have equal costs to the next hop. Ethernet Circuit #1- 200M Ethernet Circuit #2 – 100M Can I aggregate both ethernet circuits so that the total amount of bandwidth available [...]
We have set up Network Load Balancing (NLB) on two Hub Transport/Client Access servers. (Windows Server 2008/Exchange Server 2007) When we go directly to either of the nodes, we can access OWA just fine. However, when we try to go to the new NLB cluster, by name or IP address, we get this: The page [...]
We have set up Network Load Balancing (NLB) on two Hub Transport/Client Access servers. (Windows Server 2008/Exchange Server 2007) When we go directly to either of the nodes, we can access OWA just fine. However, when we try to go to the new NLB cluster, by name or IP address, we get this: The page [...]





