• linksys voip

    how can i reset linksys phone adapter ?

    Anajankis5 pointsBadges:
  • Two Subnets – Three Routers + DSL Modem

    Is the following setup valid for creating two subnets (192.168.2.xxx and 192.168.3.xxx) that both access a single internet connection but are isolated? ROUTER A WAN --> DSL Modem ROUTER B WAN --> ROUTER A LAN  ROUTER C WAN --> ROUTER A LAN  Settings: Router A  WAN - PPoE, etc. etc. LAN...

    Hashlock5 pointsBadges:
  • Load Balancing Application?

    With a project that i am heading up we are going to be using a linux box to maintain our load balancing for our network and on the NIC as we will be having a lot of information flowing through the NIC.  I am loading Ubuntu 9.10 on the box as our tester.  Any assistance would be greatly...

    Jhazard11240 pointsBadges:
  • Why can’t I connect to the Internet through my new GBIC module?

    On the MDF Rack is a Linksys switch that has 24 ports with two mini gigabit interface converter (GBIC) modules: One GBIC module port states up to 12; the other port states up to 24. [o:p][/o:p] Also, there are two fiber patch panels with 12-pair wires connected to Ports 1-2 3-4 5-6 7-8 9-10 11-12...

    NetworkingATE1,545 pointsBadges:
  • bandwidth manager

    I have a linsys wireless router. Model No.WRT54GR Some of the users are abusing the bandwidth making it difficult for others to surf the internet. Is there any way to set limits to each user so that nobody ends up using too much of the internet.The router is attached to a pc and serve as gateway.

    Chawal5 pointsBadges:
  • VoIP – Incoming DTMF tone problem

    I have Verizon Home 768 DSL service. Verizon gives you a Westell 6100 modem, and the DSL shares the same line with my landline phone. I also have T-Mobile At Home VOIP. The VOIP worked great until a month ago. Suddenly, my 2 line answering machine no longer responded to incoming DTMF tones over the...

    TheWAK5 pointsBadges:
  • Multiple public IP’s from 1 internet connection on different networks?

    Is this a possible scenario? A cable modem is hooked up via ethernet to a Linksys 5-port switch. That switch is then hooked to a Cisco SOHO router (not managed by me) and my Linksys router. I cannot get my public IP to work on my router but the Cisco routers public ip comes up fine. I have all of...

    GatekeeperJB45 pointsBadges:
  • Problem in Linksys Wireless G ADSL Home Gateway

    Hi, I am using Linkys modem (model : annex -A) i am configure the modem using rechargable card,encapsulation is RFC 2516 pppoE,multiplexing is LLC,qos type is UBR,autodetect is Enabled,Dsl modulation is ADSL2+, vpi/vci is 0.35, after save changes i see the stsatus interface is up, but i try to...

    Elite20 pointsBadges:
  • Can I use a Linksys BEFSR41 as a hub connected to a Linksys WRT150N?

    I have replaced my BEFSR41 VER 3 with a WRT150N. Can I use the BEFSR41 as a hub connected to the 150N?

    Grntech5 pointsBadges:
  • How does one setup a Windows 2003 Enterprise Server on one machine with 2 nics?

    I have read a book (O'Reily) on setting up windows server 2003 and at my current job I am fortunate enough to be able to work/play with their servers which are also windows 2003. In this, I have a bit of experience, however I ran into a few problems when trying to setup my own personal network at...

    Pr0970 pointsBadges:
  • Re-configuration of a Linksys VoIP device.

    After I configured my Linksys VoIP device, it worked perfectly for a few days, but now, all of a sudden, the application will not open. Is there any way to configure a solution?

    Unified Communications ATE2,280 pointsBadges:
  • Cisco 2960 & Cisco Linksys SRW 2024

    What is the difference between Cisco 2960 Switch and Cisco Linksys SRW2024?

    Bops5 pointsBadges:
  • Network Drop

    Hello, I am gowind to run a network drop using Cat 5E 350MHz CMR cable running from a guest house to the main house. The guest house has a Linksys router from which point i will run the Cat 5E around the outside of the house, drop down and burry in pvc pipe to main house, totaling roughly about 300...

    Thegeek5 pointsBadges:
  • Do I have to provide each PC with an IP address when using an unmanaged switch?

    Hi, I have a modem/router provided by a service provider which I connected to a 24 port unmanaged SWITCH (linksys sr224), the current TCP/IP setting in all of my pc is in automatically obtained mode. Everytime the modem/router of the service provider is broken or not connected, my local area...

    Chrptan20 pointsBadges:
  • Network Controller

    Recently while troubleshooting my wireless card, I deleted my Network Controller from my laptop and now cannot re-install it. I did so by going into Device Manager and removing it from the list. I've tried updating the driver by allowing XP to search online, find automatically and by putting in the...

    Maveric15 pointsBadges:
  • wireless software on fresh XP install

    I had to wipe the hard drive on my laptop clean and reinstall XP. How do I get my laptop to connect to my linksys router again? I tried to connect to the internet with the ethernet cable from my home PC to maybe download wireless software, but was still unable to connect...what can I do?

    Cessna38475 pointsBadges:
  • router

    I was thinking about buying a laptop and a linksys router but i wanted to know if the PC and my laptop could both be on the computer at the same time. My PC is a dell, ISP is DSL and its current 'router' is a westell model 2200. I also had another question. If i brought my laptop over to someone...

    Jmonkey10 pointsBadges:
  • Linksys systems error message-help

    When I open my service I get the following message: access violation @address 004074CDin moduleWMP54GSv1_100000368 -Linksys Wireless Network Monitor. Any suggestions for a fix?

    Cronewoman20 pointsBadges:
  • I’m searching for a large scale SIP based analog/IP convertor

    We are deploying a large scale VoIP system (+/- 5000 phones), based on Asterisk and SIP. In some of our warehouses we want to keep using the existing analog phones. We have 2 options (that we know of) to connect these analog phones to our VoIP system: 1) Linksys SPA2102 analog/IP convertor...

    Johan Leroy5 pointsBadges:
  • having a drop in wireless connection

    I have a wireless network setup with a Linksys 160 now, it was on a netgear. i change wireless routers because i thought that it was the router that was the problem, but it isnt. My computer and a PS3 are both hardwired to the router, my parents computer and laptop and my PSP are wireless....

    Shady9015 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following