Layer 3-7 Switches Questions

1

One DHCP server for two VLANS with different subnets
Hi all, How do I configure a same DHCP for two different VLANs. My setup is say VLAN 10 is having DHCP server with IP 10.102.1.2 VLAN 10 with subnet 10.102.1.1/16 VLAN 170 with subnet 192.168.10.1/22 VLAN 10 clients are getting DHCP, then what I have to configure in layer advanced switch to do get [...]

Answer Question   |  April 19, 2013  1:21 PM
DHCP, Layer 3-7 Switches, Switches, VLAN
asked by:
20 pts.

Uploads bringing network down
We do web design so the volume of traffic going out to our live production servers is considerably high at times. So my question is, without upgrading our hardware (see below), is there any way to stop uploads from bringing the entire network to its knees? I’ve got a small LAN that has between 30 [...]

Answer Question   |  August 11, 2005  9:59 AM
Bandwidth, DataCenter, Gigabit ethernet, IT architecture, Layer 3-7 Switches, Network management software, Network Management Systems, Network monitoring, Networking, Networking Equipment, Performance management, Routers, Switches, T-1/T-3 Services
asked by:
0 pts.

Creation of VLAN
How can I set up four VLANs on L3 (cisco 4507R 32 Ports) with Central Router and Database Server access provided for all VLANs, but maintain security between them (i.e. so nobody from the first VLAN can gain access to the second VLAN and vice versa but can access VLAN 4 which has Central Router [...]

Answer Question   |  July 28, 2005  3:19 AM
Layer 3-7 Switches
asked by:
0 pts.

Content Load Balancing Switches
Hi all – I’m working on a network design for a colo-based service site which will be load balancing both http and MySql (authenticated) services, and I’m looking at two possible solutions. 1) One of the Nortel Alteon content switches (low end) or 2) The Cisco CSS-11052 content switch. I’m somewhat familiar with the Alteon’s [...]

Answer Question   |  August 5, 2005  3:58 PM
Cabling, Cisco, Hardware, Hubs, Layer 3-7 Switches, Networking, Networking Products, Nortel, Routers, Switches, Vendor support
asked by:
1,070 pts.

Configuring managed switch and router in order to have Internet…
Dear Sir, Could you please help me concerning the following matter: I have Cisco Catalyst 2950 managed switch connected to Linksys WRT54G – Wireless-G Broadband Router, which is then connected to ADSL modem. I need the following scenario: -two VLANs configured on the managed switch, so there will be no traffic between. But for the [...]

Answer Question   |  April 27, 2011  11:35 AM
Layer 3-7 Switches, Modems/Cable Modems, Network Management Systems, Networking, Networking Equipment, Routers, Switches
asked by:
0 pts.

command for restricting users to one limit on cisco AS5300 at a time
Pls I need a command that will enable me to limit the access of dial up users to one log on at a time. I used username name user-maxlinks 1 password pwd. it still allow one username to be used more than one user at a time. pls waiting for responses

Answer Question   |  February 23, 2005  4:51 AM
Bandwidth, Dial-up networking, Layer 3-7 Switches, Network Management Systems, Networking, Networking Equipment, Remote management, Security
asked by:
0 pts.

vlan configuration
hi i’m having problems to configure vlan on a zoltrix 16-port switch. the switch does not have a console port but have jumpers with ‘home vlan’ and ‘trunk’ labels. please help. note: very urgent

Answer Question   |  February 17, 2005  3:25 AM
Layer 3-7 Switches, Network testing, Networking, Networking Equipment, Switches
asked by:
0 pts.

bandwidth distribution-2
hi all, can u tell me how isps distribute bandwidth to the customers(both dial up and leased)how to check that proper distribution is taking place and everyone is getting the correct bandwidth.is there any software that could b used to keep an eye?what else can be done?how to control??? thanks…

Answer Question   |  February 11, 2005  3:25 AM
Availability, Bandwidth, Benchmarking, Cabling, DataCenter, Development, DHCP, Dial-up networking, DNS, Fault isolation, Gigabit ethernet, Hubs, Layer 3-7 Switches, Managed Services, Modems/Cable Modems, Network applications management, Network Interface Cards, Network management software, Network Management Systems, Network monitoring, Network testing, Networking, Networking Equipment, Networking services, Performance management, Protocol analysis, QoS, Remote management, Routers, Security
asked by:
0 pts.

bandwidth distribution
hi all, can u tell me how isps distribute bandwidth to the customers(both dial up and leased)how to check that proper distribution is taking place and everyone is getting the correct bandwidth.is there any software that could b used to keep an eye?what else can be done?how to control??? thanks…

Answer Question   |  February 14, 2005  3:18 AM
Availability, Bandwidth, Benchmarking, Cabling, DataCenter, Development, DHCP, Dial-up networking, DNS, Fault isolation, Gigabit ethernet, Hubs, Layer 3-7 Switches, Managed Services, Modems/Cable Modems, Network applications management, Network Interface Cards, Network management software, Network Management Systems, Network monitoring, Network testing, Networking, Networking Equipment, Networking services, Performance management, Protocol analysis, QoS, Remote management, Routers, Security
asked by:
0 pts.

dial up connections
hello everybody, could u please help me understand how dial up connections r given?if i am an isp how will i assign dynamic ip addresses to my clients and how will i monitor them? thanks xevier

Answer Question   |  January 5, 2005  11:35 PM
DataCenter, DHCP, Dial-up networking, DNS, ISDN Equipment/Services, Layer 3-7 Switches, Modems/Cable Modems, Network Interface Cards, Network management software, Network Management Systems, Network testing, Networking, Networking services, VPN
asked by:
0 pts.

Load balancing on Windows 2003 server
Greetings, i just would like to ask some questions about the load balancing of windows 2003 server.I would like to ask if how would you know that the two server is doing load balancing?I’m using unicast and my two server is located in 1 vlan.Do i need some software tools to see if my two [...]

Answer Question   |  December 21, 2007  5:31 AM
Layer 3-7 Switches, Windows Server 2003
asked by:
0 pts.

asked by:
5 pts.

1