I have a cisco 3560G and 2911 series router.The Router has 2 internet interface.One is already configured to an unmanaged switch.The second interface is also configure and it can go to the internet.My task is to configure vlans on the switch and the vlans should communicate with each others.Also each of the vlans should have [...]
How do I extend 2 vlans over a WAN link. I’m using 2 routers and simulated the WAN by connecting 2 paradyne modems back to back with a cross cable. both routers are seeing each other. switch-> router1->modem->modem->router2->workstations. I need to be able to see the vlans on router 2 and to run applications on [...]
Hi All, I’m looking for solution/help to solve this issue. Scenario: Two vlans (Data & Voice) are created in my switch (3560). I ‘ve voice router (2900 series) & braodband gateway which connects to the service provider. [strong]Note: Two vlans are connected to two different interfaces of a router (traditional inter vlan routing ) requirement [...]
I am using Cisco Packet Tracer 5.2 for study, it seem to be good. I have configure Intervaln routing on 3 coreswitches which is workign fine with vast topology. I tried to place one router 2811 as a firewall between my wan and lan. But i am not able to ping from router to core [...]
I want to configure interVLAN useing two ROUTER with two SWITCH i am unable two configure it can you help me how can i configure it
Hi im trying to get my head round if this is at all possible. i have a load of 3524 switches and a single 2620 with 1 ethernet port. is it possible to have setup in this configuration with the equipment i have this part i am ok with and understand vlan6 – switch management [...]
We have enabled interVLAN routing on a layer3 switch, but when we try to ping between one VLAN and other VLANs, only some of the PCs are able to ping and the rest are not. We have 6 VLANs and in all cases we are experiencing the same situation.
We have three virtual local area networks (VLANs) as follows: 1 data, 2 voice and 3 wireless. We have 6506e at the core, and interVLAN routing is working fine. The problem is implementing FortiGate firewall in transparent mode and terminating the ISP on the router with Ethernet output. I am not able to route VLANs [...]
I have a router connected with Fast Ethernet to switch in VTP Server Mode (containing 2 VLANs) and then connected to a switch in transparent mode with three VLANs and after it a single switch in client mode. All these switches belong to the same domain and I have done interVLAN routing in it and [...]
I amm using two cisco 3750 and I want Interdomin routing. I connect two host to one 3750 and make a trunk to communicate with other 3750. Ping from host to switch(Directly connected to host) is ok. ping from switch to switch is ok(Through trunk) But when i ping a host to swich that is [...]





