Bandwidth, CCNA, Cisco, Cisco Routers, Cisco switches, DHCP, DNS, Ethernet, FTP, Hubs, IP address, IP addressing, IPv6, LAN, LDAP, Linksys, Network, Network administration, Network connectivity, Network design, Network management software, Network monitoring, Network protocols, Network security, Network Security Management, Network testing, Networking certifications, Networking Equipment, Networking services, NIC, Performance management, Ping, Protocol analysis, Remote access, Remote management, Router configuration, Routers, Subnets, Switches, TCP, TCP/IP, VLAN, VLAN configuration, VPN, WAN, Wireless, Wireless Access Points, Wireless in 2010, Wireless networking, Wireless routers VIEW ALL TAGS
On a Cat 5 cable with four pairs I know that you can get 10/100 TX out of one pair which is the IEEE 802 standard. But can you also utilize the other two pairs for an additional 10/100 TX network drop? Will this work? Where is it stated that you cannot do this if it does work and someone is saying...
I am trying to figure out if that I can legally run a CAT 5 cable and use all four pairs to utilize 2 ethernet 100tx drops. If so is does that deviate from the IEEE 802 standard. If this is possible do both drops still have good quality 10/100 tx network drops.