how does duplex work in relation to switches and hubs
how does duplex work in relation to switches and hubs

Answer Question   |  February 10, 2011  4:41 PM
duplex, Full Duplex, Hubs, Swicthes

How do I configure network ports to full-duplex on McData switches?
I want to know how to configure a network port on my McDATA Intrepid 6140 switch to full-duplex. Until now it’s been on half-duplex.

Answer Question   |  January 7, 2010  7:28 PM
configuration, Full Duplex, Half Duplex, Networking, Port

Half duplex vs full duplex
Recently the application running on one of our clusters had problems when some of the servers had problems accessing the NFS storage. The analysis showed there to be a mismatch between the QFE interfaces and the network protocol. The QFEs were operating at half duplex while the network was expecting full. The cluster servers had [...]

Answer Question   |  July 21, 2009  6:11 PM
Full Duplex, Half Duplex, Network Interface Cards, NFS, NFS Storage, RAID

Show a peer why spending the extra money for a full duplex RF link is better than half for a WAN bridge
Where can I find reference material to show a peer why spending the extra money for a full duplex RF link is better than half for a WAN bridge? I have 20+ years of networking experience and this RF guy thinks he knows it all. He has management sold on a cheap solution. I’m not [...]

Answer Question   |  May 12, 2008  8:45 PM
Bridges, Full Duplex, Link Options, Networking, Routing and switching, WAN hardware

T1 full duplx circuit
On a full duplex T1 circuit how fast can you go at the same time in both directions? Is it 1,544meg in both directions at the same time or 768k at the same time at the same time/ Thanks Jim.

Answer Question   |  April 24, 2008  3:25 PM
Full Duplex, T1

communications
What is it that determines whether or not a given network is half or full duplex?

Answer Question   |  February 1, 2008  5:48 PM
Communications services, Full Duplex, Network