• XenServer on Hitachi BladeSymphony 320

    I have installed XenServer on a blade inside a Hitachi BladeSymphony 320. The issue i have is that it doesnt recognize the FC HBA Any suggestions

    ITKE352,565 pointsBadges:
  • Need SAN upgrade suggestions

    Need to upgrade our SAN due to performance limitations of the HP MSA2000 using fibre channel to connect to our xen servers Any suggestions on products and your experiences Thanks

    JimmyIT1,725 pointsBadges:
  • NetApp drive replacement warranty contract vs not

    So I have taken a job where the entire network is falling apart and I have a couple NetApp filers. The FAS 3020 is still under contract and working fine with 7.0.4. It uses Seagate ST3146807FC FC-AL 10.6k 146GB fibre disks. The F840 however has a couple broken disks that need to be replaced and is...

    pwjohnston10 pointsBadges:
  • Any common tool for measuring controller throughput?

    I was searching for a long time for a simple tool which can tell us the controller throughput of any SAN environment. Its necessary for every Storage engineer to have this utility to cross verify the subsystem we buy. Ofcourse the vendor will have the tool or LAB benchmark for the same. But those...

    GuruBhai95 pointsBadges:
  • How many of you are considering FCoE as a transition from Fibre Channel to Ethernet?

    How many of you are considering FCoE as a transition from Fibre Channel to Ethernet?

    DellStorage30 pointsBadges:
  • Fibre Channel Card Drivers to access SCSI layer

    Are there comercially available Fibre Channel Cards with drivers that allow direct access to the low level SCSI commands on a disk?

    Wharrison0615 pointsBadges:
  • Do 10Gbit iSCSI and 8Gbit FC change how you think about your strategy for managing your data in the future?

    Do 10Gbit iSCSI and 8Gbit FC change how you think about this and your strategy for managing your data in the future?

    ITKE352,565 pointsBadges:
  • EMC Clariion CX700 Problems – Data Sector Invalidated

    Hello, I have two EMC Clariion CX700's (which, for convenience we call CX700-1 and CX700-2) and one recently added CX3-40 in my SAN environment using fiber-switch fabric. Over the weekend, I experienced a hardware failure on SPA on CX700-1. After having it replaced by my vendor's technician and...

    UniCal0 pointsBadges:
  • Reverse FC/iSCSI Gateway

    I have a FC SAN in place and want to purchase an iSCSI array to segregate some data from the rest of the SAN members. I know of a few iSCSI gateways that all iSCSI initiators to talk to a FC target. I want to do the opposite...FC initiators to an iSCSI target. Does anyone know of a gateway type...

    LUN-atic5 pointsBadges:
  • Are you using both Fibre Channel and iSCSI in your storage environment?

    The Storage Experts from Dell are interested in knowing you thoughts on this question: Are you using both Fibre Channel and iSCSI in your storage environment, or do you favor one over the other? If you have questions for the Storage Experts from Dell read this blog post on how to start the...

    ITKE352,565 pointsBadges:
  • IBM DS4300 SAN Storage Acceptance document

    Hello there, I was wondering if somebody could provide me with some guidance in preparing an acceptance document for the installation of a Fiber Channel SAN storage based on an IBM DS4300. This will help me ensure that the installation is fully implemented and all the features are enabled and...

    Akouider0 pointsBadges:
  • SAN fiber channel interconnect

    Could someone describe the materials required for a fiber channel interconnect for a backbone network. I assume it is a switch, fiber patch "cables" and pci cards for server. Could someone give me information and/or a reference to vendors.

    Mousejn5 pointsBadges:
  • Help with IBM ds6800 storage array. can’t assign storage unit to complex.

    Getting a message that says the storage management console server can not be contacted. we've never installed one of these before, but been to IBM training on it. training was uselsess for implementation from scratch. has anyone done one of these and can tell me where we are going wrong? will be...

    Japeters0 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following