XP and Z drive
Does XP connect to anything with the Z drive) during the logon process on a 2000 domain?

Answer Question   |  January 25, 2005  1:07 PM
DataCenter
asked by:
0 pts.

Hard Disk Data Recovery – NTFS MBR Failure-2
Hello everyone, I have a Western Digital 800JB ATA 80GB 7200rpm drive that was used for a time as a boot drive for WXPP. It was replaced recently as a boot drive by a smaller 40GB drive, and the 80GB drive relegated to backup duties (slaved to a CD drive on a 40-wire cable). Before [...]

Answer Question   |  January 26, 2012  7:12 AM
Adapters/Interfaces, AMD PC hardware, Backup & recovery, DataCenter, Desktops, Disk drives, Hardware, Help Desk, Intel PC hardware, Storage, Storage products and equipment, Tech support, Third-party services, Vendor support
asked by:
0 pts.

Hard Disk Data Recovery – NTFS MBR Failure
Hello everyone, I have a Western Digital 800JB ATA 80GB 7200rpm drive that was used for a time as a boot drive for WXPP. It was replaced recently as a boot drive by a smaller 40GB drive, and the 80GB drive relegated to backup duties (slaved to a CD drive on a 40-wire cable). Before [...]

Answer Question   |  January 27, 2012  7:12 AM
Adapters/Interfaces, AMD PC hardware, Backup & recovery, DataCenter, Desktops, Disk drives, Hardware, Help Desk, Intel PC hardware, Storage, Storage products and equipment, Tech support, Third-party services, Vendor support
asked by:
0 pts.

LSA shell error
I trying to solve a problem with a users computer that I need a little help with. I have just finished installing XP with service pack 2 on the computer and it keeps giving me a LSA Shell (Export Version), error message can anyone shed a little light on this subject for me. If any [...]

Answer Question   |  January 29, 2005  4:36 PM
DataCenter, Networking
asked by:
0 pts.

Defrag 725 GB ona Windows 2000 Server: Pros and Cons
Good morning! I hae had some performance issues on a Win 2K files server and have been given a recommendation to defrag the system. I am reluctant to do so for two reasons: 1. We do not have an alternate server to place these files while defragging 2. The 2K server is configured as a [...]

Answer Question   |  February 1, 2012  9:25 AM
Desktops, Help Desk, Information risk management, Operating system platforms, Servers, Tech support, Windows 2000 Server
asked by:
0 pts.

RUNAS error: Unable to acquire user password
I am trying to write a VBScript that will use local admin rights to run another script. However, for some reason I can’t get the RUNAS command to take the password. I am including my script below: set WshShell = CreateObject(“WScript.Shell”) WshShell.Run (“%comspec% /k RUNAS /user:/LocalACCOUNT/LOCALcomputerNAME C:proxyDISABLE.vbs”) Wscript.Sleep 500 WshShell.Sendkeys “PASSWORD~” The exact error is: [...]

Answer Question   |  January 28, 2005  3:08 AM
Desktops, Hardware, Policies, Security, Windows XP
asked by:
0 pts.

Desktop to AS/400 encrypted communications
We currently have many users connecting to multiple AS/400 servers using TCP/IP. The servers OS vary from V4R5 to V5R3. Several products are used to communicate through the network from the desktops to the different servers. We are looking for a solution that will encrypt the information being passed between the PC desktop to the [...]

Answer Question   |  January 25, 2005  1:04 PM
Administration, Architecture/Design, Biometrics, DataCenter, Digital certificates, Documentation, Features/Functionality, Identity & Access Management, Implementation, Installation, IT architecture, Management, Planning, provisioning, Security, Security management, Security tokens, Service and support, Single sign-on, Tech support, VPN
asked by:
0 pts.

TopIndex property for .NET Web ListBox
I’m trying to automatically scroll down to the last inserted item in a multi-select ListBox when only a few of the total # of rows are visible. Windows.Forms ListBox control has a TopIndex property that allows you to do that, but there is no similar property for the Web control. Note: In a single selection [...]

Answer Question   |  January 22, 2005  9:44 AM
ASP, ASP.NET, C, DataCenter, Development, Hardware, HTML, Lifecycle development, Manufacturing applications, Perl, Programming Languages, Retail/point-of-sale applications, Special-purpose software, SQL, T-SQL, VB.NET, Web development tools, XML
asked by:
0 pts.

Mapping of drives on Netware servers on Windows clients.
This may or may not be obvious. But I was curious if there’s any other way to MAP drives on Netware servers on Windows 2000 and/or XP clients besides the normal MAP commands via login script? This has been used since DAY 1 I would believe… are there any other ways. I’m assuming ZENWORKS could [...]

Answer Question   |  February 21, 2005  12:17 PM
DataCenter, Microsoft Windows, Novell NDS
asked by:
0 pts.

Lower TCO of IT Infrastructure
I am a Net Admin with a medium sized company running a mixed NT domain. I am fairly new to the industry and I am looking to lower our TCO of our network. I believe that we have way too many machines to support our users and applications. We have about 30 stations and we [...]

Answer Question   |  January 24, 2005  12:05 PM
Implementation, IT architecture, Planning
asked by:
0 pts.

goldmine kicking user out
Hi, im new to this forum so here goes. One of our users is having some trouble with her goldmine. when she gets to the “Document Management Center” and tries to open a document goldmine locks up and closes it has been working correctly until yesterday and the GMLINK is installed . The goldmine installation [...]

Answer Question   |  January 19, 2005  4:48 AM
DataCenter, Help Desk, Intel PC hardware, Networking, Servers, Tech support
asked by:
0 pts.

error in event viewer SAM cannot start listen thread for TCP/IP or IPX/SPX in dutch it says SAM kan luisterthreadvoor TCP/IP of SPX/IPX niet starten
what is the cause of this error and how can i tackle this because i think that it is slowing down my network

Answer Question   |  January 19, 2005  4:09 AM
DataCenter, Network protocols
asked by:
0 pts.

Deleting journal receivers
HI, When I try to delete a journal receiver that hasn’t been saved, I get the “never fully saved” message even though I’m using DLTOPT(*IGNINQMSG) Does anyone have a piece of code that will get rid of receivers no matter what? E.G. not saved, remote, attached…… Thanks

Answer Question   |  October 11, 2010  11:04 AM
Backup & recovery, Database Management Systems, DB2, DB2 administration, Hardware, i5, iSeries, OS/400, Performance/Tuning, Servers, tips and tricks, Tools
asked by:
0 pts.

Microsoft Exchange
I have a small office of 7 computers(XP Pro) and a server(Windows 2000) runing exchange 5.5 i have resently reloaded two of these computers and install sp2, for some reason these computers keep losing exchange, if the system is idle for a few minutes and try to open MS outlook (2003) I get a message [...]

Answer Question   |  January 19, 2005  2:35 AM
DataCenter, DHCP, DNS, Help Desk, Networking, Networking services, Tech support
asked by:
0 pts.

Make records(values) as a column header
Hi, I have a table 1, table2. table 1 ======== id, — Primary Key fname, lname, birth_dt, status table2 ——- id, — FK reference to table 1 survey_id table3 ——- Qid, — PK survey_id, — FK reference to table 2 question — has values like q1, q2, q3, .. ans also I wants to store [...]

Answer Question   |  January 16, 2005  3:36 PM
DataCenter, Lifecycle development
asked by:
0 pts.

Operations Navigator – Management Central
I am unable to connect to Management Central system. We are on V5R1M0, the TCP/IP connectivity is fine, job log for “qypsjsvr” show – CPFB9A1 Management central connection failed. Please help

Answer Question   |  January 19, 2005  2:10 AM
DataCenter, Development, Hardware, Networking, Security
asked by:
0 pts.

Improve IT Infrastructure
Dear All, i need your contribution to help a small enterprise. The new Finance Officer (a friend) ask me to audit is Infrastructure and make proposal for immediate implementation in order to improve security and company equipment performance. Here is tha actual infrastructure: -1 IT help desk sstaff -1 ADSL 128up/1024down (alcatel speedtouch 150) + [...]

Answer Question   |  January 21, 2005  1:34 PM
Business/IT alignment, Implementation, IT architecture, Networking, ROI & cost justification, Security, Tech support, xDSL
asked by:
0 pts.

Security COncern, Files deleted from Server
Good morning to all, and hope everyone is dooing well. I have a security issue, and need help solving this. Someone in my company within Engineering staff deleted an entire group of folders. Unfortunately it was on a project that ended, and it was discovered this morning. I have luckily a back up tape of [...]

Answer Question   |  January 24, 2005  10:21 AM
Auditing, Compliance, CRM, DataCenter, Disaster Recovery, Hardware, Intrusion management, Managed security services, Policies, Risk management, Security, Security management, Security Program Management
asked by:
0 pts.

Memory upgrade not registering
I have just upgraded the memory on my Abit AH6 motherboard from 64mb (2x32mb) to 256mb (2x128mb). When I start up the BIOS is only registering 128mb MY Computer-System Properties – General registers 128 mb and my System Information only shows 64mb. I believe this may be something to do with the BIOS but I [...]

Answer Question   |  January 14, 2005  8:12 AM
Desktops, Hardware, Tech support
asked by:
0 pts.

Windows 2000 Server – Unable to display user selection dialog
W2K Server, SP4, SQL2000, Altiris, Access database Try to add users to share permission or security, see message “unable to display user selection dialog. The specified module could not be found.” Doesn’t matter what drive, what folder, etc. I am able to remove users, but not add.

Answer Question   |  January 20, 2005  11:12 AM
Hardware, Servers
asked by:
0 pts.