• Route map Cisco

    I have a cisco router 1841. It has 2 outside adsl interfaces, and an inside interface connected to local lan. I want to use the 1st adsl interface for http, ftp and the 2nd adsl interface for the rest of the internet traffic. Below is a sample of my configuration: interface FastEthernet0/0  ip...

    Meglo161020 pointsBadges:
  • Part number for Cisco ASA5510 256MB memory module

    Hello All, Can anybody tell me the part number of 256MB memory module for Cisco ASA5510 Firewall?

    Choonapk15 pointsBadges:
  • Cisco 5510 firewall configuration

    how do i configure cisco firewall 5510 asa?

    Van helsing60 pointsBadges:
  • Do I have to use proxy with PIX firewall?

    i have pix 515E firewall and cyber roam device which is using as a proxy.do i have to use proxy with pix firewall

    Intrnetworking30 pointsBadges:
  • Cisco ASA5510

    I need to find out if there is a command to shutdown Cisco ASA5510 firewall rather then walking up to the firewall and pulling the power plug ... thanks

    Kwt712555 pointsBadges:
  • Swithces

    Can I assign two ip addresses in a cisco switch port?

    Abena5 pointsBadges:
  • How should i segment this?

    Hi, I have been given a project which basically entails segmenting hotel rooms in a hotel, on the network. The hotel is not built yet so im going to say for arguments sake there are 8 rooms on every floor, and there are 7 floors. Inside the rooms are various devices with Ethernet connectivity (a...

    LaurenceS15 pointsBadges:
  • Cisco 1548U: A managable switch?

    I have a aCsico 1548U.  Unfortunately for a project that I am working on right now we need a managable switch, and there is a huge lack of funds.  Is it possible to make the 1548U into a managable switch so that I can achieve my goal?

    Jhazard11240 pointsBadges:
  • What is the difference between a network module and interface card

    Hi i want to know what is the difference between use a Network Module 1E1 or use ans WIC 1E1.   Thanks

    Quiensoy5 pointsBadges:
  • How can I prepare for the CCNA exam in addition to my college course?

    How would you recommend that I prepare for my CCNA (Cisco Certified Network Associate) exam? I have been taking courses through my college, DeVry University, but I want to be even more prepared. The courses run us through various labs and provide us with additional material for reading. I have read...

    NetworkingATE1,545 pointsBadges:
  • cisco 1721 router install

    Our small company's new IT purchase was a Cisco 1721 router to be connected to 4 ports from our DSU/CSU T1 line. Currently we use a cable modem connection but I am trying to establish a second connection that users could take advantage of as well. My first goal is just to connect a desktop to the...

    Permits0 pointsBadges:
  • CLI config confirmation

    Hi, does anyone know if d-link is manufactured by cisco? There is this client that asked me on how to create multiple ip adresses on a single interface of cisco router, but the switch connected to it was a d-link switch. Of course, the solution was intervlan routing but I haven't seen a d-link CLI...

    Yeahboy900 pointsBadges:
  • commands for nortel ARN router against cisco 1700 series router

    as i was using cisco router and now i want to installed nortel ARN router in place of that. I have configuration backup of cisco router,so i only want Nortel ARN router commands to configure against cisco commands

    Networkfresher5 pointsBadges:
  • Cisco 2811 Fast Ethernet and LAN configuration

    i have cisco2811 router and i want to configure its 2 fast ethernet on my isp and PC or lan. can someone with a good heart to help me what command i will use on configuration level on both router and lan to have an internet connection.

    JACK15705 pointsBadges:
  • Adding a Route – Cisco router

    I have cisco 1800 series router that i want to add a route for all internet access is routed from the cable router/modem. Right now all the traffic is going over the T1 via cisco router. What i want to do is keep everything as is and only have the internet access route from the other devie. How...

    Kwt712555 pointsBadges:
  • BTS 10200 command definitions

    Are there definitions to the commands on the Cisco BTS 10200 switch whereby I can understand what each command input means

    VOIPEng5 pointsBadges:
  • Networking cisco access point

    i am working on cisco access point 1242 i had default username cisco and password Cisco but when i deleted and changed a new user name and password xxxx what happen, i can telnet through cli mode with new username and password but when i try to take http access the access point take old password...

    Ekansh400 pointsBadges:
  • QOS when receive traffic is more than transmit

    My current bandwidth is 10M. The traffic pattern is usually 2Mb transmit and 8 Mb receive from the ISP. I want to guarantee bandwidth for the WEBEX traffic which i can do for transmit traffic but my problem is that the receive traffic is whats killing me. Is there any way to make sure that my webex...

    Shane6505 pointsBadges:
  • No linestate on several CCM-lines that belongs to Cisco-SEP

    1) Can a SEP (Cisco phone) have several line connections? 2) If yes, what happens with the linestate of the lines if one line is restricted? 3) What does the below log mean? I want a linestate on ext 5228 but gets that line 5229 is restricted? Both lines is connected to same SEP. 2009-08-20...

    Runningisnew10 pointsBadges:
  • Two lines to one cisco-SEP

    What happens if there are two lines as extension mobility (user device profiles) connected/configured to one SEP where one of them is restricted? Does the other line inherit the restricted lines "configuration"?

    Runningisnew10 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following