• What are the three components that must conform to the same socket type?

    list 3 component that must conform to the same socket type

    Bigervinblye50 pointsBadges:
  • Any suggestion on the MPLS switch I need?

    I’m looking for a MPLS switch that support L2VPN, TE with at least 4x 10G interfaces. Any suggestion?

    merrysmith25 pointsBadges:
  • DIA configuration in Cisco 887 router

    How do I setup DIA configuration in Cisco 887 router?

    junukm5 pointsBadges:
  • Long Distance Phone Call

    Hi for some reason the company phone can't make long distance calls anymore. Usually you just need to dial 9 and than the number to call. I was always greeted with the messsage telling me to dial 1 or zero before dialing in the 10 digit number. Despite doing this I still can't connect. The phone...

    leungjohn30 pointsBadges:
  • Load balancing on a Cisco router

    I have three different bandwidth link & terminated on Cisco router (3900 series), I want to do load balance. i.e.If one link got down traffic should go on other two links. How do I do that?

    nazimnml5 pointsBadges:
  • SIP trunking issue: Authentication problems (CUCM and own developed PBX)

    Hey, I have built a PBX by using the Ozeki SDK and and want to connect it to my existing Cisco Unified Communications Manager PBX by using SIP trunking. By following the instructions of this Cisco setup guide, I have successfully connect the SDK to CUCM, but SIP trunking does not work, because of...

    RajeshCO275 pointsBadges:
  • HP MSA60 Replacement Procedure

    Good day. I just have a question, we have HP MSA60 and it has FAILED BATTERY RAID CONTROLLER. Does anyone knows the step-by-step procedure on the replacement? Or does anyone here knows a link of forums for servers of HP, Dell, Sun and Cisco as well. I really need to learn everything immediately....

    excellentrandy1,275 pointsBadges:
  • Public and private SSID access

    I have 1 SSID set on the Cisco wireless AP on the LAN and I want to set up another SSID with only internet access away from the LAN. In total I have 2 Cisco Access Points. Is this possible to keep them separate.

    elgan0015 pointsBadges:
  • avaya and cisco compatibility

    we have one location on our campus that has cisco voip we also have a enterpize wide avaya voip we want to convert the cisco voip to avaya but the users in that lacal do not want to give up their cisco phones IP phones are 7941 and 7961 can they be used with our avaya voip system.

    Usmavoip5 pointsBadges:
  • Activity light on Cisco Aironet AP not coming up

    I have two access point that the activity light on the NIC is not coming up, but the AP is been powered up. Can anyone tell me what this is? Does this mean that the NIC is bad? Please assist.

    piroo1015 pointsBadges:
  • IP SLA support for Cisco 7606 router

    My Cisco 7606 router iOS does not support IP SLA. Please guide me if I need to upgrade complete iOS or can I install IP SLA in existing iOS?

    mAlhi7865 pointsBadges:
  • Downloading new flash into Cisco switch

    I have a Cisco 3560G-48 switch. The flash was erased and now there is just a basic switch. I really could use some help on the procedures on downloading new flash at this point into my switch. So if you know the procedures, I really would appreciate you help. Thank you, RuizL

    warrant455 pointsBadges:
  • What is the importance of Cisco as a vendor in networking platform?

    Does anyone know what is the importance of Cisco as a vendor in networking platform?

    ponnuathira5 pointsBadges:
  • Two routers configration

    I have configured two routers completely the two router connected by them serial, router 1 can bing to interface e 0 and s 0 of router 2 and router 2 can ping interfaces e 0 and s0 of router 1 but network on e 0 of router 1 cannot bing s0 of router 2 and inverse right. What is the problem?

    Monkez50 pointsBadges:
  • VLAN trunking commands

    Sir, can you please tell me can we able to trunk one VLAN to another VLAN in same switch? The switch is Cisco 3560 series switch. If so, what will be the commands?

    Jimsanand5 pointsBadges:
  • ICRM install to VPN

    Hello, I'm using Cisco VPN connected then install ICRM. Is it possible? Its using LAN networks.

    Vickyy10 pointsBadges:
  • What’s broadcasting and which switch will fix timed-out requests?

    I am an Internet distributor of Exatt.net. When my customer pings the gateway it gives me lots of timed-out requests. Exatt.net says it broadcasts in your network. What does this mean, and how can I fix my timed-out requests? I use a hub. Someone told me to use a management switch, but I have no...

    NetworkingATE1,545 pointsBadges:
  • The whole steps and procedures to restrict internet access (http & https) for employees from a Cisco 3750 switch.

    Hello there, How can I restrict internet access to my employees around (30) and what I mean by internet access are protocols HTTP and HTTPS but allow them at the same time from connecting to the server and thus, being able to open their email (I have an exchange server on another network in another...

    Zack198315 pointsBadges:
  • VPN User IP location

    Hello, I am using Cisco VPN. We have users that connect to our company's location using CISCO VPN. Can we find out where they are located? Like what state they are connecting from. Any way to trace this?

    Imran hussain khan5 pointsBadges:
  • How to add the 2nd telphone No. in the exist UC 560 with FX0 and T1/E1 router

    I would appreciate any kind of help on this. We have a UC 560 with FX0 and T1/E1 router to handle our phone system. Now we want to add another different  phone No. with same Telephone provider in the same phone line. for example, if customer dial the exist main phone No. 1234567  then system will...

    kennyWANG5 pointsBadges:

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following