Bandwidth, CCNA, Cisco, Cisco Routers, Cisco switches, DHCP, DNS, Ethernet, FTP, Hubs, IP address, IP addressing, IPv6, LAN, LDAP, Linksys, Network, Network administration, Network applications management, Network connectivity, Network design, Network management software, Network monitoring, Network protocols, Network security, Network testing, Networking certifications, Networking Equipment, Networking services, NIC, Performance management, Ping, Protocol analysis, Remote access, Remote management, Router configuration, Routers, Subnets, Switches, TCP, TCP/IP, VLAN, VLAN configuration, VPN, WAN, Wireless, Wireless Access Points, Wireless in 2010, Wireless networking, Wireless routers VIEW ALL TAGS
Ok, I have seen this same issue on several message boards etc. but I have yet to find a good answer so here it goes. I have a network with 12 Cisco 1200 series access points all connecting to 3550PWR switches. The switches are configured with 2 vlans, one for a public wireless LAN and the other...
They are All Cisco. APs 1200 series and switches from 6509, 4506, 4006 to 3524. I have SO MANY of them and need an easier way then updating them manually. They all use SSH
Hello all, does anyone know how to change the DHCP range that a Cisco 1200 series Access point gives out, the IP for the AP is 10.20.x.x, and it give out IP's in the 192.168.x.x range, does anyone know how I can get it to change to the 10.20.x.x range as this is the range that I want the computers...