How do I get my BIOS to detect a new HDD (HDD was tested and worked)
Trying to get the BIOS to detect my new HDD, which I know works, but when I try to install XP, it says “No HDD detected, aborting”, so I checked the BIOS, and the BIOS dident even detect the HDD, so I check the cables, all is well, I also tried setting the pin to [...]

Answer Question   |  November 14, 2011  8:09 PM
ATA, BIOS, Desktop, HDD, Hewlett-Packard

Routers and the PBX
Which port do you need on the Router to connect PBX which have E&M card in it? Can a ATA with FXO port can be connected to the PBX with E&M Card?

Answer Question   |  October 19, 2009  1:42 PM
ATA, E&M Card, PBX

Disk in Array is not recognized RAID 5 configuration
I have a Highpoint ATA 454 RAID controller set up in a RAID 5 configuration with 4 disk. One of the disks in the in array is no longer recognized as a member because of one bad block. How can I “unmark” this disk as defective, and force it as a member of the array?

Answer Question   |  January 27, 2009  3:11 PM
Array, ATA, Highpoint ATA 454 RAID controller, RAID 5, Raid Controller

SCSI & ATA
what is differnce between SCSI Drive & ATA drive

Answer Question   |  August 20, 2008  2:01 PM
ATA, SCSI

ATA vs ACHI Mode vs Flash Cache Module DELL Inspiron
This is the famous little setting that is normally done on a laptop or dekstop. ATA Mode for Windows XP and ACHI Mode for WIndows Vista. Well, bless those modes, i had to use ATA mode for the setup in my new Dell Inspiron with Vista Business otherwise, i will see bluescreen almost 2-3 times [...]

Answer Question   |  January 25, 2010  3:59 PM
ACHI, Advanced Host Controller Interface (AHCI), ATA, Flash Cache Module