Comments on: Is it possible to communicate between IP of private and public network via remote desktop? http://itknowledgeexchange.techtarget.com/itanswers/networking-28/ Wed, 22 May 2013 02:14:48 +0000 hourly 1 By: pjb0222 http://itknowledgeexchange.techtarget.com/itanswers/networking-28/#comment-81067 pjb0222 Wed, 01 Sep 2010 18:33:42 +0000 #comment-81067 If you are looking to connect with remote desktop to a system on a private network from a public IP address, there are several possibilities. If it is a single desktop create a port map assignment to the specific desktop on the router, add a remote desktop gateway system/service to a compter on the private network or you can use some product like LogMeIn which can hop a NAT translation.

Note, if it is only two or three systems, you can mod the listening port for the systems so each uses a unipue port and port map through the router for each. You will need to konw which port each is listening on. If your router is advanced enough, you can do all this without changing the system port at which point you only need to konw the port on the router which points to which system.

]]> By: mitrum http://itknowledgeexchange.techtarget.com/itanswers/networking-28/#comment-81044 mitrum Wed, 01 Sep 2010 10:52:55 +0000 #comment-81044 Yes I agree with Mattmatter by appling NAT you can use internet in your private IP. So you can communicate with public network via remote desktop.

but for your privare ip you cann’t RDP by your public ip.

]]>