Q:
Network-clock-select using four PRI's.
Cisco, PRI, Primary Rate Interface, Voice/WAN interface cards, VWIC, network-clock-select, Cisco VWIC cards I have four AT&T PRI's, two VWIC-2MFT-T1 cards.
Is the following config correct?
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-select 1 T1 0/0/0
network-clock-select 2 T1 0/0/1
network-clock-select 3 T1 0/1/0
network-clock-select 4 T1 0/1/1
How would you configure this if there were 2 AT&T PRI's and 2 MCI PRI's?
Is the following config correct?
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-select 1 T1 0/0/0
network-clock-select 2 T1 0/0/1
network-clock-select 3 T1 0/1/0
network-clock-select 4 T1 0/1/1
How would you configure this if there were 2 AT&T PRI's and 2 MCI PRI's?
ASKED:
May 9 2008 8:31 PM GMT
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
0
