Home > IT Answers > Security > Interface for ASA 5510
Likom
15 pts.
 Interface for ASA 5510
Cisco ASA 5510, DHCP, Wireless Access Point
Hi , Brother/Sisters . I am using ASA 5510 with 2 interface enable ( Inside and Outside). However , I did notice ASA still have remaining port is not using. I would like to set up Wireless Access Point and direct plug into the ASA. may I know any recommendation or reading material on this? Because most of the configuration is set it up to DMZ but I just need to simply enable One interface with DHCP auto assign (do not need DMZ). May I know your opinion on this? Thanks.

Software/Hardware used:
ASKED: March 10, 2009  3:58 PM
UPDATED: March 12, 2009  3:31 AM
RELATED QUESTIONS
Answer Wiki:
Yes, the third interface is typically the DMZ. I would suggest just using the trusted side connected to a switch and then the access point connected to the switch.
Last Wiki Answer Submitted:  March 10, 2009  5:27 pm  by  Labnuke99   32,645 pts.
All Answer Wiki Contributors:  Labnuke99   32,645 pts.
To see all answers submitted to the Answer Wiki: View Answer History.


RSS - Discussions Help
Discuss This Question:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

 

Hi , Labnuke99.

Thanks your comment and I will try this method.

By the way , may I know ASA 5510 is totally impossible to enable the interface like what I propose?? As I need to explore more on this.

Thanks,

Likom
 15 pts.