I am trying to setup a network where I am running a client/server test case. In the middle, it goes through some SUT.
Client eth0 eth1 Server
[120.22.x.x/16] ---------->[Work station]<----------[120.24.x.x/16]
[switch ]-----> [SUT]
___| | |________________
|/ |/(18.104.22.168/16) |/
(22.214.171.124/16) FastEth0 (Router ) FastEth1 (126.96.36.199/16)
As you can see, the client and server are connected to the work station, at two NICs. There are three NICs in total on the work station.
eth2 is connected to a switch.
The switch is connected to each port of the Cisco router, at all three gateways:
188.8.131.52, 184.108.40.206, 220.127.116.11
The client and server HAS to be connected to the workstation, due to it is the only one that has a NIC capable of being connected to client/server.
I am using the workstation to try to forward traffic from client/server through eth2 to go to router, and go through SUT, then back again through eth2.
I tried setting up static routes, but it isn't working. I must be doing something wrong. Is this possible, to have all traffic go through one interface? eth0/1/2 are configured with no ip address via ifconfig 0.0.0.0 up command.
The problem I am having is configuring the workstation to route traffic. All other nodes are fine.
Thanks in advance!
Free Guide: Managing storage for virtual environments
Complete a brief survey to get a complimentary 70-page whitepaper featuring the best methods and solutions for your virtual environment, as well as hypervisor-specific management advice from TechTarget experts. Don’t miss out on this exclusive content!