D-Link DWL-G810 setup
I am trying to setup my D-Link DWL-G810 I have a guide on how to do it but I am confused on all the computer mumbo jumbo...(computer illiterate) -(to some degree) Anyway I have been following I But I am stuck (don't laugh) on Hardware installation part B.....Yes all I could figure out was how to plug it in. ;'] The instructions are as follows.....
For initial configuration, insert one end of the Ethernet cable into bridge and the other end into your wireless Router. Make sure you have a laptop/desktop hard wired to that wireless Router to setup the bridge.
But where I am confused is where do I connect this at? there is only one port, or place for it, I am confused on where the bridge and wireless router are.
Please help.
Computer Illiterate and hopeless
Software/Hardware used:
Software/Hardware used:
ASKED:
October 21, 2007 11:22 AM
UPDATED:
October 22, 2007 3:31 PM
Answer Wiki:
You need to connect the ethernet cable between here and your wifi router. Then configure the device. Then you can move this G810 to another area on your network and plug the ethernet cable into a device that NEEDS a hard wired connection.
This bridge simply put BRIDGES your network to somewhere where you could NOT get a wired connection.
To see all answers submitted to the Answer Wiki: View Answer History.
RSS - Discussions Help
Discuss This Question:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
