Converting a Layer 3 Switch to a Layer 2 Switch

5 pts.
Tags:
Layer 2 switches
Layer 3 switches
Switches
How do I convert a layer 3 switch to a layer 2 switch? Can I just configure the layer 3 switch as if it were a layer 2 switch?

Answer Wiki

Thanks. We'll let you know when a new response is added.

It is possible. Do not configure any Layer 3 properties by using “no ip routing” in global config. Also, you can do “switch-port mode access” for a particular port to act as Layer 2.

Discuss This Question:  

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

Thanks! We'll email you when relevant content is added and updated.

Following

Share this item with your network: