Configuring layer-3 switch to be a router

5 pts.
Tags:
L3 Switches
Network hardware
Routers
SDN
Switch configuration
How to configure L3 switch to act as router? How error frames are generated, detected, cleared in a switch?

Software/Hardware used:
Neworking

Answer Wiki

Thanks. We'll let you know when a new response is added.

If it is a cisco switch, entering the command “ip routing” at global config prompt will make it perform routing. On a port connected to a router, you will need the command ” no switchport”

Discuss This Question:  

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following