Configuring a Foundry Switch
I am not a Network Specialist, but I do know a small amount about configuring a CISCO switch. However, I have been asked to configure a Foundry Switch. I am having problems with a few commands and maybe someone out there can help me out. Here is what I'm getting when I try and configure this Foundry Switch.
version 12.0
no service pad [equivalent cmd not found]
service timestamps debug uptime [equivalent cmd not found]
service timestamps log uptime [equivalent cmd not found]
ip subnet-zero [equivalent cmd not found]
interface VLAN1
ip address 10.10.1.80 255.255.255.0
no ip directed-broadcast [no cmd available here]
no ip route-cache [no cmd available here]
config# vlan 1
config-vlan-1#ip-subnet 10.10.1.80 255.255.255.0
error: invalid subnet mask 255.255.255.0
line con 0 [equivalent cmd not found]
exec-timeout 0 0
password
login
transport input none
stopbits 1
line vty 0 4 [equivalent cmd not found]
password
login
line vty 5 15 [equivalent cmd not found]
password
login
Can someone point me in the right direction?
Software/Hardware used:
Software/Hardware used:
ASKED:
August 21, 2008 11:10 PM
UPDATED:
September 10, 2008 5:23 PM
Answer Wiki:
Here is a <a href="http://www.foundrynet.com/services/documentation/siCLI/index.html"> Link</a> to an online manual that has the various commands used to configure a Foundry Switch.
Good Luck
***************************************************
To see all answers submitted to the Answer Wiki: View Answer History.
RSS - Discussions Help
Discuss This Question:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
