Configure PIX to allow access to Remote Web Workplace and Exchange Server on SBS 2003
We have the following network configuration:
Router
--------
Outside: Static IP from ISP
Inside: IP Address: 10.0.0.1 (Static)
DHCP enabled for all other clients
Pix
-------
Ouside: 10.0.0.2 (DHCP from Router: Resvered)
Inside: 192.168.2.254 (Static)
Network
----------
192.168.2.0 255.255.255.0
All clients allocated IP from SBS DHCP
Gateway set to 192.168.2.254 (PIX Inside)
This configuration has worked fine for the last 18 months without any problems. Now we need to enable remote access to Remote Web Workplace and we are implementing Exchange. If we remove the PIX then everything works fine (ports were forwarded to the SBS for this test). We have port forward on the router ports 443, 444 and 4125 to the PIX. I need help with the ACL's on the PIX to ensure that are then forwarded to the SBS server. I am unsure whether this is NAT or PAT and what the commands should be.
Any help would be gratefully received.
Software/Hardware used:
Software/Hardware used:
ASKED:
August 27, 2008 11:59 AM
UPDATED:
August 27, 2008 12:09 PM
Answer Wiki:
Last Wiki Answer Submitted:
Be the first to answer this question.
All Answer Wiki Contributors:
Be the first to answer this question.
To see all answers submitted to the Answer Wiki: View Answer History.
RSS - Discussions Help
Discuss This Question:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
