Commands for binding or mapping Layer 2 data to Layer 3 ports
Home > IT Answers > Networking > Commands for binding or mapping Layer 2 data ...
NetworkingATE
1445 pts.
0
Q:
Commands for binding or mapping Layer 2 data to Layer 3 ports
Networking, Network hardware, Routing and switching, COMMANDS, Layer 3, Cisco Routers, Mapping, Cisco switches, binding, layers, Layer 2
I have a question concerning Layer 2 and Layer 3 data on the same device. We have a client that will be sending us Layer 2 data streams, but we have to send them to a device that will only take IP multicasts. We will be using a Cisco 7600 Router with a 6700 Switch Card installed. If this is possible with our hardware, can you point me to the commands that would allow us to bind or map the Layer 2 data to the Layer 3 port?
ASKED: Nov 7 2008  9:50 PM GMT
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
RELATED QUESTIONS
0
Sudhanshu
750 pts.
0
A:
 RATE THIS ANSWER
0
Click to Vote:
  •   0
  •  0
  • AddThis Social Bookmark Button
6700 cards are end of sale and are not supported. Ideally you need a gateway which can understand Layer 2 traffic and multicast too. Most of Cisco's routers can do that; however, commands will depend on your implementation scenario. If you can give me more details, I can help you out.
Last Answered: Nov 7 2008  9:52 PM GMT by Sudhanshu   750 pts.
  •   
0
0
RSS - Discussions Help
Discuss This Answer:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _



_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Bhupendra   190 pts.  |   Aug 11 2009  12:30AM GMT

Please describe your question with full details, then we will be able to give proper answer as per your requirement.

Thanks & Regards,
Bhupendra Singh
 <a href="mailto:bhupendra_singh007@yahoo.co.in" title="mailto:bhupendra_singh007@yahoo.co.in">bhupendra_singh007 at yahoo.co.in</a>.

 
0