I’m going to multilink 8 T1 lines until our vendor can get a DS3 in
place (we are rural).
Your current config looks like:
For the first controller card, I used channel-group 1 timeslots 1-24.
They gave me an int s0/0/0:1 My big question I guess, is with the
channel group command. Will I put ALL 4 of my VWIC-2MFT-T1 cards in
channel 1 or should each physical card have its own channel.
This is way you can configure.
Initially try to get in to router configuration page using the Ip adrress,then try to configure the router by setting each port ,by getting in to wizard set up.