Cisco PIX firewall 6 error messages
I am using PIX version 6.0 and get the following error messages
Software/Hardware used:
%PIX-1-103001: (Primary) No response from other firewalland
%PIX-1-104002: (Primary) Switching to STNDBY
Software/Hardware used:
ASKED:
November 19, 2008 9:51 PM
UPDATED:
November 20, 2008 9:16 PM
Answer Wiki:
For <a href="http://www.cisco.com/en/US/docs/security/pix/pix60/system/message/pixemsgs.html">103001</a> verify that the secondary unit has the exact same hardware, software version level, and configuration as the primary unit.
and
for <a href="http://www.cisco.com/en/US/docs/security/pix/pix60/system/message/pixemsgs.html">104002</a> If the message occurs because of manual intervention, no action is required. Otherwise, use the cause reported by the secondary unit to verify the status of both units of the pair.
To see all answers submitted to the Answer Wiki: View Answer History.
RSS - Discussions Help
Discuss This Question:
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
