Cisco 2600 Router and Two ISP

55 pts.
Tags:
Cisco 2600
Cisco router configuration
How can configure two Internet LL (Primary and backup)on same cisco router 2600 (2 Serieal and 4 ethernet ports). ISP 1 - 4Mbpes and ISP 2 - 1 Mbps.

Software/Hardware used:
cisco Router 2600 with 2 serial and 4 ethernet ports
ASKED: October 5, 2009  8:35 AM
UPDATED: October 14, 2009  2:42 PM

Answer Wiki

Thanks. We'll let you know when a new response is added.

you would have to setup routes with different matrics.
route to ISP1 metric of 1
route to ISP2 metric of 250

probably something like
ip route 0.0.0.0 0.0.0.0 10.20.30.1
ip route 0.0.0.0 0.0.0.0 10.30.20.1 250

assuming that 10.20.30.0 was to ISP1 and want to use as the primary and 10.30.20.0 was to ISP2 and uses as the secondary.

I am sure that there are other ways to do it depending on which protocols are being used with the ISPs. like BGP or RIP2 over frame-relay…etc.

Discuss This Question:  

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following