Can I create high availability (HA) with switches and network interface Card (NIC) bonding?

1,545 pts.
Tags:
Dell PowerConnect
Dell PowerConnect 6248
High Availability
Networking
NIC
Switching
What's the best way to create high availability utilizing a couple of switches and NIC bonding? I'm looking at stacking four Dell PowerConnect 6248's, then bonding two NICs on my servers and having one NIC go to one switch and the other NIC to another switch. I'm assuming if the two switches my bonded NICs are plugged into go down, then it's game over, even though I've got two other switches in the stack still up. Is there a better way go about doing this?
ASKED: June 17, 2009  8:46 PM
UPDATED: June 26, 2009  5:02 PM

Answer Wiki

Thanks. We'll let you know when a new response is added.

When you stack switches up you actually don’t provide any high availability (HA) functionality but you get more number of ports with better management. You should have both the network interface cards (NICs) connect to two different switches (you use only two switches if you have less than 48 servers) or two different stacks (if you have more than 48 servers.)

Hope this helps.

Discuss This Question: 4  Replies

 
There was an error processing your information. Please try again later.
Thanks. We'll let you know when a new response is added.
Send me notifications when members answer or reply to this question.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy
  • NetworkingATE
    I don't think you can bond together two nics and have them on different switches. They should be on the same switch and bonded together (trunked) on the switch side also. In the IT trenches? So am I - read my IT-Trenches blog
    0 pointsBadges:
    report
  • BlankReg
    Troy, that is not correct. Many of the Cisco switches allow you to do this. They act together as a single switch and you can trunk to different switches to produce the high availability. Now whether the Dell switches are capable of doing that, I don't know. Probably not. You get what you pay for.
    12,325 pointsBadges:
    report
  • R0berth1
    It will not allow youdo span switches with the trunk with PAgP, you have to change the protocol to LACP. that will allow you to have a 2 or more switch stack and have a port from each switch as a member of the portchannel.
    175 pointsBadges:
    report
  • NetworkingATE
    Thanks for the clarification. I was unsure about my answer so it is nice to get additional details.
    0 pointsBadges:
    report

Forgot Password

No problem! Submit your e-mail address below. We'll send you an e-mail containing your password.

Your password has been sent to:

To follow this tag...

There was an error processing your information. Please try again later.

REGISTER or login:

Forgot Password?
By submitting you agree to receive email from TechTarget and its partners. If you reside outside of the United States, you consent to having your personal data transferred to and processed in the United States. Privacy

Thanks! We'll email you when relevant content is added and updated.

Following