Comments on: AS400 – Sysopr MSG ” CHG0064″

By: splat

splat — Mon, 23 May 2011 15:07:49 +0000

If you receive the message again, use F9=Display message details to determine which job sending it.

By: syedm

syedm — Fri, 20 May 2011 05:53:23 +0000

Thanks everyone for the reply and suggestions

I was not installing any application when this message appeared, bytheway I already passed this message to our development/software support team for further investigation

By: tomliotta

tomliotta — Thu, 19 May 2011 23:57:59 +0000

The message ID CHG0064 and text that includes “Account Reconcilemnet Services” is almost certainly an application message. We have no way to know for sure what it means.

It looks like it means someone should mount a tape in the tape drive, and then type ‘G’ in the message display and press .

Usually a ‘G’ tells programs to ‘go’ and ‘C’ tells programs to ‘cancel’. You respond to the message with ‘G’ after you mount the tape in the drive because you want the program to start going again after a tape is ready.

But we can only guess because we don’t have the same programs that you have.

Tom

By: hmssl2k

hmssl2k — Thu, 19 May 2011 19:20:37 +0000

We do need more info to give you a better answer